MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 177

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Serial Over LAN—MPCBL0050
9.8.2.6
9.9
September 2007
Order Number: 318146-001
To end the SOL session:
SOL is stopped completely and the serial console port is now redirected to the front
panel of the SOL target blade.
Recovering SOL Session if ipmitool Segfaults
If ipmitool segfaults while in a SOL session and another SOL session is immediately
activated, ipmitool will not be able to establish a new session because no SOL close
session occurred. Ipmitool is still receiving encrypted packets from the previous SOL
session and is expecting to receive encrypted packets that are responses to the new
SOL session establishment commands.
There are two ways to recover:
Deactivate the SOL session:
Reactivate the SOL session:
Operating Systems for SOL Client (ipmitool)
The SOL client utility (ipmitool) can be compiled to work with any Linux* OS.
1. Type:
2. After typing
• Wait for 60 seconds + 3 seconds (approximately) before establishing new SOL
• Using ipmitool, do an explicit Deactivate and then Activate a new SOL session:
console screen. This is done at the login prompt.)
the target blade SOL session is deactivated, type the following command:
session. The IPMC firmware takes 60 seconds (session timeout) to clear the
session.
# ipmitool -I lanplus -L operator -H <SOL Target IP Addr>
# ipmitool -I lanplus -L operator -H <SOL Target IP Addr>
# ipmitool -I lanplus -L operator -H <SOL Target IP Addr>
~
-U solusername -P soluserpassword sol deactivate
-U solusername -P soluserpassword sol activate
. (Note: After pressing
-U solusername -P soluserpassword sol deactivate
~
the SOL session deactivates on the SOL target blade. To make sure
~
just once, this symbol does not appear on the
Intel NetStructure
®
MPCBL0050 Single Board Computer
Technical Product Specification
177