MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 42

no-image

MPCBL0050N02Q

Manufacturer Part Number
MPCBL0050N02Q
Description
Manufacturer
Intel
Datasheet

Specifications of MPCBL0050N02Q

Lead Free Status / RoHS Status
Supplier Unconfirmed
Table 10.
3.4
Warning:
Note:
Table 11.
Intel NetStructure
Technical Product Specification
42
®
Backplane and on-board connector assignments
DIP Switches
The MPCBL0050 contains a number of DIP switches that allow the user to configure
certain options not configurable through the EFI Setup utility. These DIP switches are
used for diagnostic purposes. Users should take precautions when changing these
switches. See
describe DIP switches functionality.
Changing any of the “Reserved” switches to position other then default may render the
MPCBL0050 instable or prevent the board from powering up. It is advised to check DIP
switches for valid configuration always before inserting board into the chassis.
The DIP switch descriptions presented below
only to the production version of the MPCBL0050 (only 3 DIP switch modules on the
board: SW1, SW2, SW3). For details on preproduction boards, please contact your Intel
representative.
DIP switch SW1
Connector
J2
U28
U29
U30
U31
J20
J23
J30
J31
J32
J33
P10
SW1-3
Switch
SW1
MPCBL0050 Single Board Computer
Pos#
1
2
Description
AdvancedMC* connector
FBDIMM1 connector (Branch0-Channel0)
FBDIMM2 connector (Branch0-Channel1)
FBDIMM3 connector (Branch1-Channel2)
FBDIMM4 connector (Branch1-Channel3)
AdvancedTCA data transport for Update Channel (Zone2)
AdvancedTCA data transport for Base and Fabric Interface (Zone2)
RTM Power connector (Zone 3)
RTM Data and Control connector (Zone 3)
RTM Data and Control connector (Zone 3)
RTM Data and Control connector (Zone 3)
Advanced TCA Power and IPMB
DIP Switches. Refer to the chapter
Figure 16
Signal Name
N/A
N/A
for the locations of the DIP switches. The following tables
Switch setting
RESERVED
RESERVED
“DIP Switches” on page 42
(Table
11,
Table
MPCBL0050—Connectors and LEDs
12, and
Order Number: 318146-001
Table
September 2007
13) apply
Default
Off
Off