F39-EU1E Omron, F39-EU1E Datasheet - Page 56

• Manufacturer Part Number: F39-EU1E
• Description: F3S-B OPTIONAL PROGRAMMING KIT
• Manufacturer: Omron

Specifications of F39-EU1E

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Light Curtain Type: Safety
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com
Process 5
Process 6
Process 7
Cleaning
Cooling
Coating
http://www.ia.omron.com/
1. Upon completion of automatic soldering, use a fan
2. Fully sealed relays are washable. Do not, however,
Refer to the following table to select the cleaning
method and solvent.
Cleaning Method
1. With the G7S, G7SA or G7SB coating will
2. Be very careful in selecting the coating material.
Neither boiling cleaning nor immersion cleaning is
possible.
Clean only the back of the PCB with a brush.
or other device to forcibly cool the PCB. This helps
prevent the Relay and other components from
deteriorating from the residual heat of soldering.
put fully sealed relays in a cold cleaning solvent
immediately after soldering or the seals may be
dameged.
penetrate inside Relays and damage the contacts.
Therefore either do not apply coating at all or apply
the coating first, before mounting the Relays.
Depending on the type of coating selected, it may
damage the Relay case and chemically dissolve
the seals, causing them to lose their sealing
capability.
G7S
G7SA
G7SB
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
Cooling
3. Do not secure the entire Relay in resin, or the
Relay's characteristics will be changed.
Do not exceed the maximum value for the coating's
ambient operating temperature.
G7SA
Required
Precautions for All Relays
G7SB
C-14