AT32UC3L-EK Atmel, AT32UC3L-EK Datasheet - Page 86

• Manufacturer Part Number: AT32UC3L-EK
• Description: KIT EVAL AVR32 UC3 MCU
• Manufacturer: Atmel
• Type: MCUr

Specifications of AT32UC3L-EK

• Contents: *
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: UC3L
• Kit Contents: Board
• Features: USB / Battery Powered, Board Controller / Bootloader
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Tool Type: Starter Kit
• Cpu Core: AVR 8
• Data Bus Width: 8 bit
• Processor Series: AT32
• Processor To Be Evaluated: AT32UC3L064
• Interface Type: USB, Capacitive Touch
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

32099F–11/2010
through a dedicated Peripheral Bus address. Some of the general-purpose fuse bits are
reserved for special purposes, and should not be used for other functions:
Table 8-2.
General-
Purpose fuse
number
15:0
16
19:17
21:20
22
General-purpose Fuses with Special Functions
Name
LOCK
EPFL
BOOTPROT
SECURE
UPROT
Usage
Region lock bits.
External Privileged Fetch Lock. Used to prevent the CPU from
fetching instructions from external memories when in privileged
mode. This bit can only be changed when the security bit is
cleared. The address range corresponding to external
memories is device-specific, and not known to the Flash
Controller. This fuse bit is simply routed out of the CPU or bus
system, the Flash Controller does not treat this fuse in any
special way, except that it can not be altered when the security
bit is set.
If the security bit is set, only an external JTAG or aWire Chip
Erase can clear EPFL. No internal commands can alter EPFL if
the security bit is set.
When the fuse is erased (i.e. "1"), the CPU can execute
instructions fetched from external memories. When the fuse is
programmed (i.e. "0"), instructions can not be executed from
external memories.
This fuse has no effect in devices with no External Memory
Interface (EBI).
Used to select one of eight different bootloader sizes. Pages
included in the bootloader area can not be erased or
programmed except by a JTAG or aWire chip erase.
BOOTPROT can only be changed when the security bit is
cleared.
If the security bit is set, only an external JTAG or aWire Chip
Erase can clear BOOTPROT, and thereby allow the pages
protected by BOOTPROT to be programmed. No internal
commands can alter BOOTPROT or the pages protected by
BOOTPROT if the security bit is set.
Used to configure secure state and secure state debug
capabilities. Decoded into SSE and SSDE signals as shown in
Table
AVR32UC Technical Reference Manual for more details on
SSE and SSDE.
If programmed (i.e. “0”), the JTAG USER PROTECTION
feature is enabled. If this fuse is programmed some HSB
addresses will be accessible by JTAG access even if the flash
security fuse is programmed. Refer to the JTAG documentation
for more information on this functionality. This bit can only be
changed when the security bit is cleared.
8-4. Refer to the AVR32 Architecture Manual and the
AT32UC3L016/32/64
86