IPTR-DSPBUILDER Altera, IPTR-DSPBUILDER Datasheet - Page 390

• Manufacturer Part Number: IPTR-DSPBUILDER
• Description: DSP BUILDER SOFTWARE
• Manufacturer: Altera
• Type: DSPr

Specifications of IPTR-DSPBUILDER

• Function: DSP Builder
• License: Renewal License
• Software Application: IP CORE, DSP BUILDER
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Supported Families: Arria GX, Arria II GX, Cyclone, Stratix
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable

11–16
Table 11–9. Stratix EP2S180 DSP Board Blocks
DSP Builder Standard Blockset Libraries
f
Block
A2D_1 and A2D_2
D2A_1 and D2A_2
IO_DEV_CLRn
LED0–LED7
PROTO and
PROTO1
PROTO2
PROTO3
Display0 and
Display1
SW4–SW7
For information about setting up the board, refer to the
Started User
the
Figure 11–14
7-segment display and LEDs on the board respond to user-controlled switches and
the value of the incrementer.
Stratix II EP2S180 DSP Development Board Reference
Guide. For information about the supported hardware features, refer to
Mictor connector, which controls the debugging port. You can optionally specify
Controls the 12-bit signed analog-to-digital converters (U1, U2). You can optionally
specify the clock signal.
Controls the 14-bit unsigned digital-to-analog converters (U14, U15)
Controls the board reset push-button switch (SW8). You can optionally specify the
clock signal.
Controls eight user-definable LEDs (D1–D8).
Santa Cruz connectors, which controls the prototyping area I/O. You can optionally
specify Input or Output node type, specify the input clock signal, and specify the
pin locations (J23– J25, J26–J28).
Input or Output node type, specify the input clock signal, and specify the pin
location for each port (J20).
External analog-to-digital converter interface connector. You can optionally specify
Input or Output node type, specify the input clock signal, and specify the pin
location for each port (J5, J6).
Controls a dual user-definable seven-segment LED display (U12, U13).
Controls four user-definable push-button switches (SW4–SW7). You can optionally
specify the clock signal.
shows the design example for the Stratix II EP2S180 DSP board. The
Preliminary
Description
Manual.
DSP Development Kit Getting
© June 2010 Altera Corporation
Stratix II EP2S180 DSP Board
Chapter 11: Boards Library