ATSAM3S-EK Atmel, ATSAM3S-EK Datasheet - Page 385

• Manufacturer Part Number: ATSAM3S-EK
• Description: KIT EVAL FOR ATSAM3S4C
• Manufacturer: Atmel
• Series: SAM3Sr
• Type: MCUr

Specifications of ATSAM3S-EK

• Contents: Board, Cables, Power Supply
• Silicon Manufacturer: Atmel
• Core Architecture: ARM
• Core Sub-architecture: Cortex-M3
• Kit Contents: Board
• Features: TFT Colour LCD Display, SD/MMC Interface
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Figure 23-22. TDF Mode = 0: TDF wait states between read and write accesses on the same chip select
23.12 External Wait
23.12.1
6500C–ATARM–8-Feb-11
write2 controlling signal
read1 controlling signal
Restriction
A[23:0]
(NWE)
(NRD)
D[7:0]
MCK
Any access can be extended by an external device using the NWAIT input signal of the SMC.
The EXNW_MODE field of the SMC_MODE register on the corresponding chip select must be
set to either to “10” (frozen mode) or “11” (ready mode). When the EXNW_MODE is set to “00”
(disabled), the NWAIT signal is simply ignored on the corresponding chip select. The NWAIT
signal delays the read or write operation in regards to the read or write controlling signal,
depending on the read and write modes of the corresponding chip select.
When one of the EXNW_MODE is enabled, it is mandatory to program at least one hold
cycle for the read/write controlling signal. For that reason, the NWAIT signal cannot be
used in Page Mode
(“Slow Clock Mode” on page
The NWAIT signal is assumed to be a response of the external device to the read/write request
of the SMC. Then NWAIT is examined by the SMC only in the pulse state of the read or write
controlling signal. The assertion of the NWAIT signal outside the expected period has no impact
on SMC behavior.
TDF_CYCLES = 5
read1 cycle
read1 hold = 1
(“Asynchronous Page Mode” on page
Read to Write
Wait State
391).
TDF_CYCLES = 5
4 TDF WAIT STATES
SAM3S Preliminary
393), or in Slow Clock Mode
write2 setup = 1
(optimization disabled)
TDF_MODE = 0
write2 cycle
385