HD64F3437STF16V Renesas Electronics America, HD64F3437STF16V Datasheet - Page 263

• Manufacturer Part Number: HD64F3437STF16V
• Description: MCU 3/5V 60K PB-FREE 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300r

Specifications of HD64F3437STF16V

• Core Processor: H8/300
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: Host Interface, I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

11.4.4
If a switch is made between watchdog timer mode and interval timer mode while the WDT is
operating, correct operation may not be performed. The WDT must be stopped (by clearing the
TME bit to 0) before changing the timer mode.
11.4.5
If the RESO output signal is input to the chip’s RES pin, the chip will not be initialized correctly.
Ensure that the RESO signal is not logically input to the chip’s RES pin. When resetting the entire
system with the RESO signal, use a circuit such as that shown in figure 11.8.
11.4.6
The following points should be noted when using the microcomputer’s on-chip watchdog timer to
detect program runaway.
During program runaway, instructions other than the usual instructions may be executed. If an
instruction reserved for system use is executed as a result of runaway, the watchdog timer may
sometimes stop, preventing detection of the runaway.
This problem can be avoided by making the following settings in the program.
1. Set code H'0004 in ROM address H'0002.
2. Set code H'56F0 in ROM address H'0004.
As system reserved addresses may be used by an emulator, the above settings should only be made
for the actual chip.
Reset signal to entire chip
Switching between Watchdog Timer Mode and Interval Timer Mode
System Reset by RESO Signal
Detection of Program Runaway
Figure 11.8 Sample Circuit for System Reset by RESO Signal
Reset input
H8/3437 Series chip
RESO
RES
231