EP1S20F780I6N Altera, EP1S20F780I6N Datasheet - Page 502

• Manufacturer Part Number: EP1S20F780I6N
• Description: IC STRATIX FPGA 20K LE 780-FBGA
• Manufacturer: Altera
• Series: Stratix®r

Specifications of EP1S20F780I6N

• Number Of Logic Elements/cells: 18460
• Number Of Labs/clbs: 1846
• Total Ram Bits: 1669248
• Number Of I /o: 586
• Voltage - Supply: 1.425 V ~ 1.575 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 780-FBGA
• Family Name: Stratix
• Number Of Logic Blocks/elements: 18460
• # I/os (max): 586
• Frequency (max): 450.05MHz
• Process Technology: 0.13um (CMOS)
• Operating Supply Voltage (typ): 1.5V
• Logic Cells: 18460
• Ram Bits: 1669248
• Operating Supply Voltage (min): 1.425V
• Operating Supply Voltage (max): 1.575V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 780
• Package Type: FC-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Compliant

Source-Synchronous Timing Budget
Source-
Synchronous
Timing Budget
5–30
Stratix Device Handbook, Volume 2
■
■
■
■
This section discusses the timing budget, waveforms, and specifications
for source-synchronous signaling in Stratix devices. LVDS, LVPECL,
PCML, and HyperTransport I/O standards enable high-speed data
transmission. This high data-transmission rate results in better overall
system performance. To take advantage of fast system performance, you
must understand how to analyze timing for these high-speed signals.
Timing analysis for the differential block is different from traditional
synchronous timing analysis techniques.
Rather than focusing on clock-to-output and setup times, source-
synchronous timing analysis is based on the skew between the data and
the clock signals. High-speed differential data transmission requires you
to use timing parameters provided by IC vendors and to consider board
skew, cable skew, and clock jitter. This section defines the source-
synchronous differential data orientation timing parameters, and timing
budget definitions for Stratix devices, and explains how to use these
timing parameters to determine a design's maximum performance.
Differential Data Orientation
There is a set relationship between an external clock and the incoming
data. For operation at 840 Mbps and W = 10, the external clock is
multiplied by 10 and phase-aligned by the PLL to coincide with the
sampling window of each data bit. The third falling edge of high-
frequency clock is used to strobe the incoming high-speed data.
Therefore, the first two bits belong to the previous cycle.
shows the data bit orientation of the ×10 mode as defined in the
Quartus II software.
After the pattern detection state machine, use another synchronizing
register to capture the generated SYNC signal and synchronize it to
the
Since the skew in the path from the output of this synchronizing
register to the PLL is undefined, the state machine must generate a
pulse that is high for two
Since the SYNC generator circuitry only generates a single fast clock
period pulse for each SYNC pulse, you cannot generate additional
SYNC pulses until the comparator signal is reset low.
To guarantee the pattern detection state machine does not incorrectly
generate multiple SYNC pulses to shift a single bit, the state machine
must hold the SYNC signal low for at least three
between pulses.
×
1 clock.
×
1 clock periods.
×
1 clock periods
Altera Corporation
Figure 5–23
July 2005