h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 700

• Manufacturer Part Number: h8s-2635
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 16 Controller Area Network (HCAN)
16.2.20 Module Stop Control Register C (MSTPCRC)
Note: * The MSTPC2 is not available and is reserved in the H8S/2635 and H8S/2634.
MSTPCRC is an 8-bit readable/writable register that performs module stop mode control.
When the MSTPC3 and MSTPC2 bits are set to 1, HCAN0 and 1 operation is stopped at the end
of the bus cycle, and module stop mode is entered. Register read/write accesses are not possible in
module stop mode. For details, see section 23A.5, 23B.5, Module Stop Mode.
MSTPCRC is initialized to H'FF by a reset, and in hardware standby mode. It is not initialized in
software standby mode.
Bit 3—Module Stop (MSTPC3): Specifies the HCAN module stop mode.
Bit 2—Module Stop (MSTPC2) * : Specifies the HCAN module stop mode.
Note: * The MSTPC2 is not available and is reserved in the H8S/2635 and H8S/2634.
Rev. 6.00 Feb 22, 2005 page 640 of 1484
REJ09B0103-0600
Bit 3: MSTPC3
0
1
Bit 2: MSTPC2
0
1
Initial value:
R/W:
Bit:
MSTPC7 MSTPC6 MSTPC5 MSTPC4 MSTPC3 MSTPC2 * MSTPC1 MSTPC0
R/W
Description
HCAN0 module stop mode is cleared
HCAN0 module stop mode is set
Description
HCAN1 module stop mode is cleared
HCAN1 module stop mode is set
7
1
R/W
6
1
R/W
5
1
R/W
4
1
R/W
3
1
R/W
2
1
R/W
1
1
(Initial value)
(Initial value)
R/W
0
1