h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 984

• Manufacturer Part Number: h8s-2635
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 21C ROM (H8S/2635 Group)
However, the RAM area overlapping flash memory space can be read and written to regardless of
whether the SWE bit is set or cleared.
Do not use interrupts while flash memory is being programmed or erased: All interrupt
requests, including NMI, should be disabled during FWE application to give priority to
program/erase operations.
Do not perform additional programming. Erase the memory before reprogramming: In on-
board programming, perform only one programming operation on a 128-byte programming unit
block. In programmer mode, too, perform only one programming operation on a 128-byte
programming unit block. Programming should be carried out with the entire programming unit
block erased.
Before programming, check that the chip is correctly mounted in the PROM programmer:
Overcurrent damage to the device can result if the index marks on the PROM programmer socket,
socket adapter, and chip are not correctly aligned.
Do not touch the socket adapter or chip during programming: Touching either of these can
cause contact faults and write errors.
Rev. 6.00 Feb 22, 2005 page 924 of 1484
REJ09B0103-0600