h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 885

• Manufacturer Part Number: h8s-2635
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 21B ROM (H8S/2638 Group, H8S/2639 Group, H8S/2630 Group)
To select user program mode, select a mode that enables the on-chip flash memory (mode 6 or 7),
and apply a high level to the FWE pin. In this mode, on-chip supporting modules other than flash
memory operate as they normally would in modes 6 and 7.
The flash memory itself cannot be read while the SWE bit is set to 1 to perform programming or
erasing, so the control program that performs programming and erasing should be run in on-chip
RAM or external memory. If the program is to be located in external memory, the instruction for
writing to flash memory, and the following instruction, should be placed in on-chip RAM.
Figure 21B-10 shows the procedure for executing the program/erase control program when
transferred to on-chip RAM.
*
*
*
Figure 21B-10 User Program Mode Execution Procedure
Rev. 6.00 Feb 22, 2005 page 825 of 1484
REJ09B0103-0600