C8051F302 Silicon Laboratories Inc, C8051F302 Datasheet - Page 104

• Manufacturer Part Number: C8051F302
• Description: IC 8051 MCU 8K FLASH 11MLP
• Manufacturer: Silicon Laboratories Inc
• Series: C8051F30xr

Specifications of C8051F302

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 25MHz
• Connectivity: SMBus (2-Wire/I²C), UART/USART
• Peripherals: POR, PWM, Temp Sensor, WDT
• Number Of I /o: 8
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x8b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 11-VQFN
• Data Bus Width: 8 bit
• Data Ram Size: 256 B
• Interface Type: I2C, SMBus, UART
• Maximum Clock Frequency: 25 MHz
• Number Of Programmable I/os: 8
• Number Of Timers: 16 bit
• Operating Supply Voltage: 2.7 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: No

C8051F300/1/2/3/4/5
13.1. Supporting Documents
It is assumed the reader is familiar with or has access to the following supporting documents:
13.2. SMBus Configuration
Figure 13.2 shows a typical SMBus configuration. The SMBus specification allows any recessive voltage between
3.0 V and 5.0 V; different devices on the bus may operate at different voltage levels. The bi-directional SCL (serial
clock) and SDA (serial data) lines must be connected to a positive power supply voltage through a pull-up resistor or
similar circuit. Every device connected to the bus must have an open-drain or open-collector output for both the SCL
and SDA lines, so that both are pulled high (recessive state) when the bus is free. The maximum number of devices
on the bus is limited only by the requirement that the rise and fall times on the bus not exceed 300 ns and 1000 ns,
respectively.
104
1.
2.
3.
VDD = 5V
The I
The I
System Management Bus Specification -- Version 1.1, SBS Implementers Forum.
2
2
C-Bus and How to Use It (including specifications), Philips Semiconductor.
C-Bus Specification -- Version 2.0, Philips Semiconductor.
Figure 13.2. Typical SMBus Configuration
VDD = 3V
Master
Device
Rev. 2.3
VDD = 5V
Device 1
Slave
VDD = 3V
Device 2
Slave
SDA
SCL