HD6417709SF133B Renesas Electronics America, HD6417709SF133B Datasheet - Page 489

• Manufacturer Part Number: HD6417709SF133B
• Description: IC SUPERH MPU ROMLESS 208LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417709SF133B

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 96
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.65 V ~ 2.05 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -

Bit 2—Transmit End (TEND): Indicates that when the last bit of a serial character was
transmitted, SCTDR did not contain valid data, so transmission has ended. TEND is a read-only
bit and cannot be written to.
Bit 1—Multiprocessor Bit (MPB): Stores the value of the multiprocessor bit in receive data
when a multiprocessor format is selected for receiving in asynchronous mode. MPB is a read-only
bit and cannot be written to.
Note: * If RE is cleared to 0 when a multiprocessor format is selected, MPB retains its
Bit 0—Multiprocessor Bit Transfer (MPBT): Stores the value of the multiprocessor bit added to
transmit data when a multiprocessor format is selected for transmitting in asynchronous mode.
The MPBT setting is ignored in synchronous mode, when a multiprocessor format is not selected,
or when the SCI is not transmitting.
Bit 2: TEND
0
1
Bit 1: MPB
0
1
Bit 0: MPBT
0
1
previous value.
Description
Transmission is in progress
[Clearing condition]
TEND is cleared to 0 when software reads TDRE after it has been set to 1, then
writes 0 to TDRE.
End of transmission
[Setting conditions]
(1) TEND is set to 1 when the chip is reset or enters standby mode.
(2) When TE is cleared to 0 in the serial control register (SCSCR).
(3) If TDRE is 1 when the last bit of a one-byte serial character is transmitted.
Description
Multiprocessor bit value in receive data is 0 *
Multiprocessor bit value in receive data is 1
Description
Multiprocessor bit value in transmit data is 0
Multiprocessor bit value in transmit data is 1
Rev. 5.00, 09/03, page 443 of 760
(Initial value)
(Initial value)
(Initial value)