PEF 20525 F V1.3 Infineon Technologies, PEF 20525 F V1.3 Datasheet - Page 215

no-image

PEF 20525 F V1.3

Manufacturer Part Number
PEF 20525 F V1.3
Description
IC CTRL PPP/HDLC SERIAL TQFP-100
Manufacturer
Infineon Technologies
Datasheet

Specifications of PEF 20525 F V1.3

Function
Serial Optimized Communications Controller
Interface
ASYNC, BISYNC, HDLC, PPP
Number Of Circuits
2
Voltage - Supply
3 V ~ 3.6 V
Current - Supply
50mA
Power (watts)
150mW
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
100-LFQFP
Includes
Bit Processor Functions, Serial Communication Controllers (SCCs)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
PEF20525FV1.3X
PEF20525FV13XP
SP000007592
6
6.1
After Reset the CPU has to write a minimum set of registers and an optional set
depending on the required features and operating modes.
First, the following initialization steps must be taken:
• Select serial protocol mode (refer to
• Select encoding of the serial data (refer to
• Program the output characteristics of
• Choose a clock mode (refer to
• Power-up the oscillator unit (with or without shaper) by re-setting bit GMODE:OSCPD
The clock mode must be set before power-up (CCR0H.PU). The CPU may switch the
SEROCCO-H between power-up and power-down mode. This has no influence upon the
contents of the registers, i.e. the internal state remains stored. In power-down mode
however, all internal clocks are disabled, no interrupts from the corresponding channel
are forwarded to the CPU. This state can be used as a standby mode, when the channel
is (temporarily) not used, thus substantially reducing power consumption.
The SEROCCO-H should usually be initialized in Power-Down mode.
The need for programming further registers depends on the selected features (serial
mode, clock mode specific features, operating mode, address mode, user demands).
6.2
6.2.1
In transmit direction 2 ´ 32 byte FIFO buffers (transmit pools) are provided for each
channel. After checking the XFIFO status by polling the Transmit FIFO Write Enable bit
(bit ’XFW’ in
bytes may be entered by the CPU into the XFIFO.
The transmission of a packet can be started by issuing an ’XF’ or ’XIF’ command via the
CMDRL
and PREAMB) are sent out optionally before transmission of the current packet starts.
Data Sheet
Page
Page
- pin TxD (selected with bit ’ODS’ in
Byte)” on Page
- interrupt pin INT/INT (selected with bit field ’IPC(1:0)’ in
Page
to ’0’, if appropriate (GMODE:DSHP=’0’ enables the shaper).
83),
74),
112),
register. If enabled, a specified number of preambles (refer to registers
Programming
Initialization
Interrupt Mode
Data Transmission (Interrupt Driven)
STARL
143) and
register) or after a Transmit Pool Ready (’XPR’) interrupt, up to 32
Table 7 "Overview of Clock Modes" on Page
215
“Channel Configuration Register 1 (Low
Table 12 "Protocol Mode Overview" on
Chapter 3.2.13 “Data Encoding” on
“Global Mode Register” on
Programming
PEB 20525
PEF 20525
2000-09-14
CCR2H
47).

Related parts for PEF 20525 F V1.3