PEF 20525 F V1.3 Infineon Technologies, PEF 20525 F V1.3 Datasheet - Page 63

• Manufacturer Part Number: PEF 20525 F V1.3
• Description: IC CTRL PPP/HDLC SERIAL TQFP-100
• Manufacturer: Infineon Technologies

Specifications of PEF 20525 F V1.3

• Function: Serial Optimized Communications Controller
• Interface: ASYNC, BISYNC, HDLC, PPP
• Number Of Circuits: 2
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 50mA
• Power (watts): 150mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 100-LFQFP
• Includes: Bit Processor Functions, Serial Communication Controllers (SCCs)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: PEF20525FV1.3X; PEF20525FV13XP; SP000007592

PEB 20525
PEF 20525
Functional Overview
3.2.3.7
Clock Mode 5b (Octet Sync Mode)
This operation mode has been designed for applications using Octet Synchronous PPP.
It is based on clock mode 5a, but only 8-bit (octet) wide time slot operation is supported,
i.e. bits TTSA1.TEPCM and RTSA1.REPCM must be set to ’1’. Clock mode 5b provides
octet alignment to time slots if Octet Synchronous PPP protocol mode or extended
transparent mode is selected.
Note: For correct operation NRZ data coding/encoding should be used.
The receive and transmit clocks are separate and must be supplied at pins RxCLK and
TxCLK. The SCC receives and transmits only during fixed octet wide time-slots of
programmable location with respect to the octet synchronization signals (via pins OSR
and OST)
The time-slot locations can be programmed independently for receive and transmit
direction via registers
TTSA0..TTSA3
/
RTSA0..RTSA3
and
PCMTX0..PCMTX3
/
PCMRX0..PCMRX3.
Figure 25
shows how to select one or more octet wide time-slots.
Bit ’TSCM’ in register
CCR1H
determines whether the internal counters are continuously
running even if no synchronization pulse is detected at OST/OSR signals or stopping at
their maximum value.
In the continuous case the repetition rate of operation is 1024 transmit or receive clocks
respectively. An OST/OSR pulse detected earlier resets the corresponding offset
counter and starts operation again.
In the non-continuous case the transmit/receive time slot assigner offset counter is
stopped after the counter reached its maximum value and is started again if an OST/
OSR pulse is detected.
Data Sheet
63
2000-09-14