peb20534 Infineon Technologies Corporation, peb20534 Datasheet - Page 293

• Manufacturer Part Number: peb20534
• Description: Dma Supported Serial Communication Controller With 4 Channels
• Manufacturer: Infineon Technologies Corporation

Data Sheet
NRM
PPPM(1..0)
SLEN
BISNC
MCS
Normal Response Mode
This bit is valid in HDLC Automode operation only and determines the
function of the Automode LAP-Controller:
NRM = ’0’
NRM = ’1’
PPP Mode Select
This bit field enables and selects the HDLC PPP protocol modes:
PPPM = ’00’ No PPP protocol operation. The HDLC sub-mode is
PPPM = ’01’ Octet synchronous PPP protocol operation.
PPPM = ’10’ Asynchronous PPP protocol operation.
PPPM = ’11’ Bit synchronous PPP protocol operation.
SYNC Character Length
This bit selects the SYNC character length in BISYNC/MONOSYNC
operation mode:
SLEN = ’0’
SLEN = ’1’
Enable BISYNC Mode
This bit is selects BISYNC/MONOSYNC operation:
BISNC = ’0’
BISNC = ’1’
Modulo Count Select
This bit is valid in HDLC Automode operation only and determines the
control field format:
MCS = ’0’
MCS = ’1’
Full-duplex LAP-B / LAP-D operation.
Half-duplex normal response mode (NRM) operation.
determined by bit field ’MDS’.
Note: Bit ’BCR’ in register CCR0 must be set to ensure
6 bit (MONOSYNC), 12 bit (BISYNC).
8 bit (MONOSYNC), 16 bit (BISYNC).
MONOSYNC operation.
BISYNC operation.
Basic operation, one byte control field (modulo 8 counter
operation).
Extended operation, two bytes control field (modulo 128
counter operation).
proper asynchronous reception.
293
Detailed Register Description
(bisync mode)
(bisync mode)
PEB 20534
PEF 20534
(hdlc mode)
(hdlc mode)
(hdlc mode)
2000-05-30