NNDK-MOD5272-KIT NetBurner Inc, NNDK-MOD5272-KIT Datasheet - Page 264

• Manufacturer Part Number: NNDK-MOD5272-KIT
• Description: KIT DEVELOP NETWORK FOR MOD5272
• Manufacturer: NetBurner Inc
• Series: ColdFire®r

Specifications of NNDK-MOD5272-KIT

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: MOD5272
• Primary Attributes: *
• Secondary Attributes: *
• Processor To Be Evaluated: MOD5272
• Interface Type: RS-232, RS-485, USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 528-1001

Module Operation
12.2.1.1 USB Transceiver Interface
The USB module supports either an internal or external USB transceiver. USB_D+ and
USB_D- drive USB cable D+ and D- lines, respectively. With additional external protection
circuitry (see 12.5.3, “Recommended USB Protection Circuit”), equipment can be built that
complies with Universal Serial Bus Specification, Rev. 1.1. Transceiver performance
specifications are described in the Chapter 7 of the Universal Serial Bus Specification. See
note on page , [p. 12-1].
When the internal transceiver is selected, (USBEPCTL0[AFEEN] is cleared), the driven
outputs can be observed by using the parallel port A if these pins are configured for USB,
using the PACNT register, 17.2.1, “Port A Control Register (PACNT)”.
The USB module has separate power pins for the internal transceiver.
However, to reduce power consumption, USB_VDD may be left unconnected if either of
the following is true:
12.2.1.2 Clock Generator
The USB module requires two clock inputs; the system clock and a 48-MHz data clock. The
data clock source is selectable between the USB_ExtCLK pin or the system clock. The
clock generator automatically uses the external clock as the data clock if it detects the
presence of a clock signal on the USB_CLK pin during system reset. This automatic
selection can be overridden by setting bit USBEPCTL0[CLK_SEL], Section 12.3.2.13. If
a clock signal is not present on USB_CLK, the clock generator uses the system clock.
12.2.1.3 USB Control Logic
The control logic performs the following functions:
12-4
• The USB module is not used.
• An external transceiver is used.
• For transmitted data:
— Packet creation
— Parallel-to-serial conversion
— CRC generation
USB_GND should always be grounded.
In all cases, the system clock must be at least 24-MHz for the
USB module to function properly. If the system clock is used
for the USB data clock, the system clock frequency must be
48-MHz.
MCF5272 User’s Manual
NOTE:
NOTE:
MOTOROLA