D12312SVTE25 Renesas Electronics America, D12312SVTE25 Datasheet - Page 577

• Manufacturer Part Number: D12312SVTE25
• Description: MCU 3V 0K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12312SVTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 70
• Program Memory Type: ROMless
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412312SVTE25; HD6412312SVTE25

14.4.2
Scan mode is useful for monitoring analog inputs in a group of one or more channels. When the
ADST bit is set to 1 by software, or by timer or external trigger input, A/D conversion starts on the
first channel in the group (AN0). When two or more channels are selected, after conversion of the
first channel ends, conversion of the second channel (AN1) starts immediately. A/D conversion
continues cyclically on the selected channels until the ADST bit is cleared to 0. The conversion
results are transferred for storage into the ADDR registers corresponding to the channels.
When the operating mode or analog input channel must be changed during analog conversion, to
prevent incorrect operation, first clear the ADST bit to 0 in ADCSR to halt A/D conversion. After
making the necessary changes, set the ADST bit to 1 to start A/D conversion again. The ADST
bit can be set at the same time as the operating mode or input channel is changed.
Typical operations when three channels (AN0 to AN2) are selected in scan mode are described
next. Figure 14.4 shows a timing diagram for this example.
[1] Scan mode is selected (SCAN = 1), scan group 0 is selected (CH2 = 0), analog input channels
[2] When A/D conversion of the first channel (AN0) is completed, the result is transferred to
[3] Conversion proceeds in the same way through the third channel (AN2).
[4] When conversion of all the selected channels (AN0 to AN2) is completed, the ADF flag is set
[5] Steps [2] to [4] are repeated as long as the ADST bit remains set to 1. When the ADST bit is
AN0 to AN2 are selected (CH1 = 1, CH0 = 0), and A/D conversion is started (ADST = 1)
ADDRA. Next, conversion of the second channel (AN1) starts automatically.
to 1 and conversion of the first channel (AN0) starts again. If the ADIE bit is set to 1 at this
time, an ADI interrupt is requested after A/D conversion ends.
cleared to 0, A/D conversion stops. After that, if the ADST bit is set to 1, A/D conversion
starts again from the first channel (AN0).
Scan Mode (SCAN = 1)
Section 14 A/D Converter (8 Analog Input Channel Version)
Rev.7.00 Feb. 14, 2007 page 543 of 1108
REJ09B0089-0700