DF2148ATE20 Renesas Electronics America, DF2148ATE20 Datasheet - Page 467

• Manufacturer Part Number: DF2148ATE20
• Description: IC H8S MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148ATE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: Host Interface, I²C, IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2148ATE20; HD64F2148ATE20

14.5.3
If the mode is switched from watchdog timer to interval timer, or vice versa, while the WDT is
operating, errors could occur in the incrementation. Software must stop the watchdog timer (by
clearing the TME bit to 0) before switching the mode.
14.5.4
If the RESO output signal is input to the chip’s RES pin, the chip will not be initialized correctly.
Ensure that the RESO signal is not logically input to the chip’s RES pin. When resetting the entire
system with the RESO signal, use a circuit such as that shown in figure 14.8.
14.5.5
If the mode is switched between high-speed mode and subactive mode or between high-speed
mode and watch mode when WDT1 is used as a realtime clock counter, an error will occur in the
counter value when the internal clock is switched.
When the mode is switched from high-speed mode to subactive mode or watch mode, the
increment timing is delayed by approximately 2 or 3 clock cycles when the WDT1 control clock is
switched from the main clock to the subclock.
Also, since the main clock oscillator is halted during subclock operation, when the mode is
switched from watch mode or subactive mode to high-speed mode, the clock is not supplied until
internal oscillation stabilizes. As a result, after oscillation is started, counter incrementing is halted
during the oscillation stabilization time set by bits STS2 to STS0 in SBYCR, and there is a
corresponding discrepancy in the counter value.
Reset signal to entire system
Switching between Watchdog Timer Mode and Interval Timer Mode
System Reset by RESO
Counter Value in Transitions between High-Speed Mode, Subactive Mode, and
Watch Mode
Figure 14.8 Sample Circuit for System Reset by RESO
Reset input
RESO
RESO Signal
RESO
Rev. 4.00 Sep 27, 2006 page 421 of 1130
Section 14 Watchdog Timer (WDT)
RESO Signal
RESO
RESO
RES
RESO
REJ09B0327-0400
Chip