DF70844AD80FPV Renesas Electronics America, DF70844AD80FPV Datasheet - Page 1326

• Manufacturer Part Number: DF70844AD80FPV
• Description: IC SUPERH MCU FLASH 112LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7080r

Specifications of DF70844AD80FPV

• Core Size: 32-Bit
• Program Memory Size: 256KB (256K x 8)
• Core Processor: SH-2
• Speed: 80MHz
• Connectivity: EBI/EMI, FIFO, I²C, SCI, SSU
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 76
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• No. Of I/o's: 76
• Ram Memory Size: 16KB
• Cpu Speed: 80MHz
• Digital Ic Case Style: LQFP
• Supply Voltage Range: 3V To 3.6V, 4.5V To 5.5V
• Embedded Interface Type: I2C, SCI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: R0K570865S001BE - KIT STARTER FOR SH7086R0K570865S000BE - KIT STARTER FOR SH7086HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)
• Eeprom Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Section 23 Flash Memory
Rev. 3.00 May 17, 2007 Page 1268 of 1582
REJ09B0181-0300
The difference between the programming procedures in user program mode and user boot
mode is whether the MAT is switched or not as shown in figure 23.14.
In user boot mode, the user boot MAT can be seen in the flash memory space with the user
MAT hidden in the background. The user MAT and user boot MAT are switched only while
the user MAT is being programmed. Because the user boot MAT is hidden while the user
MAT is being programmed, the procedure program must be located in an area other than flash
memory. After programming finishes, switch the MATs again to return to the first state.
MAT switchover is enabled by writing a specific value to FMATS. However note that while
the MATs are being switched, the LSI is in an unstable state, e.g. access to a MAT is not
allowed until MAT switching is completely finished, and if an interrupt occurs, from which
MAT the interrupt vector is read from is undetermined. Perform MAT switching in accordance
with the description in section 23.8.1, Switching between User MAT and User Boot MAT.
Except for MAT switching, the programming procedure is the same as that in user program
mode.
The area that can be executed in the steps of the user procedure program (on-chip RAM, user
MAT, and external space) is shown in section 23.9.2, Areas for Storage of the Procedural
Program and Data for Programming.