NH82801HEM S LB9B Intel, NH82801HEM S LB9B Datasheet - Page 200
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
NH82801HEM S LB9B
Manufacturer Part Number
NH82801HEM S LB9B
Description
Manufacturer
Intel
Datasheet
1.NH82801HEM_S_LB9B.pdf
(890 pages)
Specifications of NH82801HEM S LB9B
Lead Free Status / RoHS Status
Compliant
- Current page: 200 of 890
- Download datasheet (7Mb)
Figure 14.
5.16.4.2
5.16.4.2.1
5.16.4.2.2
5.16.4.2.3
200
SATA Power States
Power State Transitions
Partial and Slumber State Entry/Exit
The partial and slumber states save interface power when the interface is idle. It would
be most analogous to PCI CLKRUN# (in power savings, not in mechanism), where the
interface can have power saved while no commands are pending. The SATA controller
defines PHY layer power management (as performed via primitives) as a driver
operation from the host side, and a device proprietary mechanism on the device side.
The SATA controller accepts device transition types, but does not issue any transitions
as a host. All received requests from a SATA device will be ACKed.
When an operation is performed to the SATA controller such that it needs to use the
SATA cable, the controller must check whether the link is in the Partial or Slumber
states, and if so, must issue a COM_WAKE to bring the link back online. Similarly, the
SATA device must perform the same action.
Device D1, D3 States
These states are entered after some period of time when software has determined that
no commands will be sent to this device for some time. The mechanism for putting a
device in these states does not involve any work on the host controller, other then
sending commands over the interface to the device. The command most likely to be
used in ATA/ATAPI is the “STANDBY IMMEDIATE” command.
Host Controller D3
After the interface and device have been put into a low power state, the SATA host
controller may be put into a low power state. This is performed via the PCI power
management registers in configuration space. There are two very important aspects to
note when using PCI power management.
When the controller is put into D3, it is assumed that software has properly shut down
the device and disabled the ports. Therefore, there is no need to sustain any values on
the port wires. The interface will be treated as if no device is present on the cable, and
power will be minimized.
When returning from a D3 state, an internal reset will not be performed.
1. When the power state is D3, only accesses to configuration space are allowed. Any
2. When the power state is D3, no interrupts may be generated, even if they are
attempt to access the memory or I/O spaces will result in master abort.
enabled. If an interrupt status bit is pending when the controller transitions to D0,
an interrupt may be generated.
Ready
PHY =
HOT
PHY =
Partial
Device = D0
State
Slumber
PHY =
Intel
®
Resume Latency
disabled)
ICH SATA Controller = D0
Off (port
PHY =
Power
Slumber
PHY =
Device = D1
disabled)
Off (port
PHY =
Slumber
PHY =
Device = D3
Intel
disabled)
Off (port
®
Functional Description
PHY =
ICH8 Family Datasheet
Related parts for NH82801HEM S LB9B
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![NH82801HEM S LA5R](/images/manufacturer_photos/0/3/336/intel_tmb.jpg)
Part Number:
Description:
Manufacturer:
Intel
Datasheet:
![RJ80535VC600512](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
![82550GY](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![G28F640J5-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-100](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
![DA28F640J5A-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
![NHE6300ESB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
![NH82801DB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet: