IPR-PCIE/1 Altera, IPR-PCIE/1 Datasheet - Page 289

• Manufacturer Part Number: IPR-PCIE/1
• Description: IP CORE Renewal Of IP-PCIE/1
• Manufacturer: Altera
• Type: MegaCorer

Specifications of IPR-PCIE/1

• Software Application: IP CORE, Interface And Protocols, PCI
• Supported Families: Arria GX, Cyclone II, HardCopy II, Stratix II
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Rohs Compliant: NA
• Function: PCI Express Compiler, x1 Link Width
• License: Renewal License
• Lead Free Status / RoHS Status: na
• Lead Free Status / RoHS Status: na

Chapter 16: SOPC Builder Design Example
Add the Remaining Components to the SOPC Builder System
Add the Remaining Components to the SOPC Builder System
December 2010 Altera Corporation
1
4. You can retain the default values for all parameters on the Capabilities, Buffer
Your system is not yet complete, so you can ignore any error messages generated by
SOPC Builder at this stage.
This section describes adding the DMA controller and on-chip memory to your
system.
1. In the System Contents tab, double-click DMA Controller in the DMA subfolder
2. In the DMA Controller parameter editor, specify the parameters or conditions
Table 16–4. DMA Controller Parameters
3. Click Finish. The DMA Controller module is added to your SOPC Builder system.
4. In the System Contents tab, double-click the On-Chip Memory (RAM or ROM)
Table 16–5. On-Chip Memory Parameters
5. Retain the default settings for all other options and click Finish.
6. The On-chip Memory component is added to your SOPC Builder system.
Parameter
Width of the DMA length register
Enable burst transfers
Maximum burst size
Data transfer FIFO depth
Construct FIFO from embedded memory blocks
Parameter
Memory type
Block type
Initialize memory content
Data width
Total memory size
Setup, and Power Management pages.
of the Memories and Memory Controllers folder. This component contains read
and write master ports and a control port slave.
listed in
in the On-Chip subfolder of the Memory and Memory Controllers folder. This
component contains a slave port.
Table
16–4.
Value
Select RAM (Writeable)
Select Auto
Turn this option off
Select 64-bit
Select 4096 Bytes
Value
13
Turn this option on
Select 1024
Select 32
Turn this option on
PCI Express Compiler User Guide
16–5