RCLXT16706FE Intel, RCLXT16706FE Datasheet - Page 294

• Manufacturer Part Number: RCLXT16706FE
• Manufacturer: Intel

Specifications of RCLXT16706FE

• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 2.97V
• Operating Supply Voltage (max): 3.63V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / Rohs Status: Not Compliant

Intel IXF6048 — 51/155/622/2488 Mbit/s SONET/SDH Cell/Packet Interface
294
Bit
5:3
2:1
7
6
0
TsalBusCnfg
XmtPrcMsohSrc
XmtE2Src[2:0]
XmtD4D12Src[1:0]
XmtUnMsohSrc
Name
Configure the Transmit input Section Alarm serial bus timings:
'0' = Contradirectional bus
'1' = Codirectional bus
This bit specifies the passing through of all the Processed MSOH bytes (B2,
K1, K2, S1 and M1) when TSOHINS input pin is disabled (TSOHINS_Ena =
‘0’ in register T_SC_RSOH[15]) or active-low on these time slots in TSOH
serial bus input. It is ignored in regenerator configuration—the received
bytes are passed through:
'0' = Internal hardware processed, serial accesses, or microprocessor
provided (normal mode) (see MstReiSrc and MstRdiSrc)
'1' = Source is Received byte from downstream (pass-through mode)
This bit specifies the source of the transmitted E2 byte when TSOHINS input
pin is disabled (TSOHINS_Ena = ‘0’ in register T_SC_RSOH[15]) or active-
low on E1 time slot in TSOH serial bus input. It is ignored in regenerator
configuration—the received byte is passed through:
'000' = Dedicated 64-Kbit/s TMOW serial input, when used
'001' = “Quiet” PCM code. Internal default value '01111111'.
'01X' = Unused. Set to internal Overhead default value (all '0's).
'1XX' = Source is received byte from downstream (passed through).
This bit specifies the source of the transmitted D4-D12 bytes when
TSOHINS input pin is disabled (TSOHINS_Ena = ‘0’ in register
T_SC_RSOH[15]) or active-low on these bytes time slots in TSOH serial
bus input. It is ignored in regenerator configuration—the received bytes
are passed through:
'00' = Dedicated 576-Kbit/s TMD serial input, when used
'01' = Unused: internal Overhead default value (all '0')
'1X' = Source is received byte from downstream (passed through)
This bit specifies the transmit source for the unused MSOH bytes (except
B2, K1, K2, D4-D12, S1, M1, E2) when TSOHINS input pin is disabled
(TSOHINS_Ena = ‘0’ in register T_SC_RSOH[15]) or active-low on these
bytes time slots in TSOH serial bus input. It is ignored in regenerator
configuration—the received bytes are passed through:
'0' = Unused bytes: set to internal Overhead default value (all '0')
'1' = Source is Received byte from downstream (passed through)
Description
Type
R/W
R/W
R/W
R/W
R/W
Datasheet
Default
'001'
'01'
'0'
'0'
'0'