R5F61525 RENESAS [Renesas Technology Corp], R5F61525 Datasheet - Page 625

• Manufacturer Part Number: R5F61525
• Description: 32-Bit CISC Microcomputer H8SX Family H8SX/1500 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 17 Flash Memory (0.18-(m F-ZTAT Version)
Initialization before Programming/Erasing: The on-chip program includes the initialization
program. A pulse with the specified period must be applied when programming or erasing. The
specified pulse width is made by the method in which wait loop is configured by the CPU
instruction. Accordingly, the operating frequency of the CPU must be set. The initial program is
set as a parameter of the programming/erasing program which has been downloaded to perform
these settings.
Programming: When the flash memory is programmed, the start address of the programming
destination on the user MAT and the program data must be passed to the programming program.
The start address of the programming destination on the user MAT must be stored in general
register ER1. This parameter is called the flash multipurpose address area parameter (FMPAR).
The program data is always in 128-byte units. When the program data does not satisfy 128 bytes,
128-byte program data is prepared by filling the dummy code (H'FF). The boundary of the start
address of the programming destination on the user MAT is aligned at an address where the lower
eight bits (A7 to A0) are H'00 or H'80.
The program data for the user MAT must be prepared in consecutive areas. The program data
must be in a consecutive space which can be accessed using the MOV.B instruction of the CPU
and is not in the flash memory space.
The start address of the area that stores the data to be written in the user MAT must be set in
general register ER0. This parameter is called the flash multipurpose data destination area
parameter (FMPDR).
For details on the programming procedure, see section 17.8.2, User Program Mode.
Erasure: When the flash memory is erased, the erase block number on the user MAT must be
passed to the erasing program which is downloaded.
The erase block number on the user MAT must be set in general register ER0. This parameter is
called the flash erase block select parameter (FEBS).
One block is selected from the block numbers of 0 to 11 as the erase block number.
For details on the erasing procedure, see section 17.8.2, User Program Mode.
Rev. 3.00 Mar. 14, 2006 Page 587 of 804
REJ09B0104-0300