HD64F3048VTF8 Renesas Electronics America, HD64F3048VTF8 Datasheet - Page 701

• Manufacturer Part Number: HD64F3048VTF8
• Description: IC H8 MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3048VTF8

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F3048VX8

Section 21 Power-Down State
21.6.3
Usage Notes
When using the module standby function, note the following points.
DMAC and Refresh Controller: When setting bit MSTOP2 or MSTOP1 to 1 to place the
DMAC or refresh controller in module standby, make sure that the DMAC or refresh controller is
not currently requesting the bus right. If bit MSTOP2 or MSTOP1 is set to 1 when a bus request is
present, operation of the bus arbiter becomes ambiguous and a malfunction may occur.
Internal Peripheral Module Interrupt: When MSTCR is set to “1”, prevent module interrupt in
advance. When an on-chip supporting module is placed in standby by the module standby
function, its registers, including the interrupt flag, are initialized.
Pin States: Pins used by an on-chip supporting module lose their module functions when the
module is placed in module standby. What happens after that depends on the particular pin. For
details, see section 9, I/O Ports. Pins that change from the input to the output state require special
care. For example, if SCI1 is placed in module standby, the receive data pin loses its receive data
function and becomes a generic I/O pin. If its data direction bit is set to 1, the pin becomes a data
output pin, and its output may collide with external serial data. Data collisions should be prevented
by clearing the data direction bit to 0 or taking other appropriate action.
Register Resetting: When an on-chip supporting module is halted by the module standby
function, all its registers are initialized. To restart the module, after its MSTCR bit is cleared to 0,
its registers must be set up again. It is not possible to write to the registers while the MSTCR bit is
set to 1.
MSTCR Access from DMAC Disabled: To prevent malfunctions, MSTCR can only be accessed
from the CPU. It can be read by the DMAC, but it cannot be written by the DMAC.
Rev. 7.00 Sep 21, 2005 page 675 of 878
REJ09B0259-0700