D12363VTE33 Renesas Electronics America, D12363VTE33 Datasheet - Page 144

• Manufacturer Part Number: D12363VTE33
• Description: MCU 3V 0K 120-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412363VTE33; HD6412363VTE33

Section 4 Exception Handling
Consequently, on-chip peripheral module registers cannot be read from or written to. Register
reading and writing is enabled when module stop mode is exited.
4.4
Traces are enabled in interrupt control mode 2. Trace mode is not activated in interrupt control
mode 0, irrespective of the state of the T bit. For details on interrupt control modes, see section 5,
Interrupt Controller.
If the T bit in EXR is set to 1, trace mode is activated. In trace mode, a trace exception occurs on
completion of each instruction. Trace mode is not affected by interrupt masking. Table 4.3 shows
the state of CCR and EXR after execution of trace exception handling. Trace mode is canceled by
clearing the T bit in EXR to 0. The T bit saved on the stack retains its value of 1, and when control
is returned from the trace exception handling routine by the RTE instruction, trace mode resumes.
Trace exception handling is not carried out after execution of the RTE instruction.
Interrupts are accepted even within the trace exception handling routine.
Table 4.3
Interrupt Control Mode
0
2
Legend:
1:
0:
—: Retains value prior to execution.
4.5
Interrupts are controlled by the interrupt controller. The interrupt controller has two interrupt
control modes and can assign interrupts other than NMI to eight priority/mask levels to enable
multiplexed interrupt control. The source to start interrupt exception handling and the vector
address differ depending on the product. For details, refer to section 5, Interrupt Controller.
The interrupt exception handling is as follows:
1. The values in the program counter (PC), condition code register (CCR), and extended register
Rev.6.00 Mar. 18, 2009 Page 84 of 980
REJ09B0050-0600
(EXR) are saved in the stack.
Set to 1
Cleared to 0
Traces
Interrupts
Status of CCR and EXR after Trace Exception Handling
CCR
I
Trace exception handling cannot be used.
1
UI
—
EXR
I2 to I0
—
0
T