D12363VTE33 Renesas Electronics America, D12363VTE33 Datasheet - Page 350

• Manufacturer Part Number: D12363VTE33
• Description: MCU 3V 0K 120-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412363VTE33; HD6412363VTE33

Section 7 DMA Controller (DMAC)
• Write data buffer function and DMAC register setting
• Write data buffer function and DMAC operation timing
7.7.4
If the last transfer cycle is for an internal address, note that even if low-level output at the TEND
pin has been set, a low level may not be output at the TEND pin under the following external bus
conditions since the last transfer cycle (internal bus cycle) and the external bus cycle are executed
in parallel.
1. Write cycle with write buffer mode enabled
2. DMAC single address cycle for a different channel with write buffer mode enabled
3. Bus release cycle
4. CBR refresh cycle
Figure 7.41 shows an example in which a low level is not output from the TEND pin in case 2
above.
If the last transfer cycle is an external address cycle, a low level is output at the TEND pin in
synchronization with the bus cycle.
However, if the last transfer cycle and a CBR refresh occur simultaneously, note that although the
CBR refresh and the last transfer cycle may be executed consecutively, TEND may also go low in
this case for the refresh cycle.
Rev.6.00 Mar. 18, 2009 Page 290 of 980
REJ09B0050-0600
If the setting of a register that controls external accesses is changed during execution of an
external access by means of the write data buffer function, the external access may not be
performed normally. Registers that control external accesses should only be manipulated when
external reads, etc., are used with DMAC operation disabled, and the operation is not
performed in parallel with external access.
The DMAC can start its next operation during external access using the write data buffer
function. Consequently, the DREQ pin sampling timing, TEND output timing, etc., are
different from the case in which the write data buffer function is disabled. Also, internal bus
cycles maybe hidden, and not visible.
TEND Output