D12363VTE33 Renesas Electronics America, D12363VTE33 Datasheet - Page 825

• Manufacturer Part Number: D12363VTE33
• Description: MCU 3V 0K 120-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412363VTE33; HD6412363VTE33

The difference between the programming procedures in user program mode and user boot mode is
whether the MAT is switched or not as shown in figure 20.13.
In user boot mode, the user boot MAT can be seen in the flash memory space with the user MAT
hidden in the background. The user MAT and user boot MAT are switched only while the user
MAT is being programmed. Because the user boot MAT is hidden while the user MAT is being
Figure 20.13 Procedure for Programming User MAT in User Boot Mode
JSR FTDAR setting + 32
Select on-chip program
to be downloaded and
and bus master operation
destination by FTDAR
Set the FPEFEQ and
Set SCO to 1 and
execute download
FUBRA parameters
Set FKEY to H'A5
specify download
procedure program
Clear FKEY to 0
Start programming
Disable interrupts
Initialization
other than CPU
DPFR = 0 ?
FPFR = 0 ?
1
Yes
Yes
Initialization error processing
Download error processing
No
No
User-boot-MAT
selection state
Section 20 Flash Memory (0.18-μm F-ZTAT Version)
Note: * The MAT must be switched by FMATS
Rev.6.00 Mar. 18, 2009 Page 765 of 980
No
JSR FTDAR setting + 16
JSR FTDAR setting + 16
Set FMATS to value other than
ER1 (FMPAR and FMPDR)
Set parameter to ER0 and
Programming finished
Set FMATS to H'AA to
to perform the programming error
processing in the user boot MAT.
select user boot MAT
H'AA to select user MAT
Set FKEY to H'A5
Clear FKEY to 0
procedure program
End programming
Programming
programming is
processing
Required data
FPFR = 0 ?
FPFR = 0 ?
completed?
1
Yes
Yes
Yes
Clear FKEY and programming
Clear FKEY and programming
No
No
error processing*
REJ09B0050-0600
error processing
switchover
switchover
MAT
MAT