D12363VTE33 Renesas Electronics America, D12363VTE33 Datasheet - Page 857

• Manufacturer Part Number: D12363VTE33
• Description: MCU 3V 0K 120-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412363VTE33; HD6412363VTE33

(6)
The boot program will transfer the erasing program, and erase the user MATs and user boot MATs
in that order. On completion of this erasure, ACK will be returned and will enter the
programming/erasing state.
The host should select the device code, clock mode, and new bit rate with device selection, clock-
mode selection, and new bit-rate selection commands, and then send the command for the
transition to programming/erasing state. These procedure should be carried out before sending of
the programming selection command or program data.
Command
• Command, H'40, (one byte): Transition to programming/erasing state
Response
• Response, H'06, (one byte): Response to transition to programming/erasing state
Error Response
• Error response, H'C0, (one byte): Error response for user boot MAT blank check
• Error code, H'51, (one byte): Erasing error
(7)
A command error will occur when a command is undefined, the order of commands is incorrect,
or a command is unacceptable. Issuing a clock-mode selection command before a device selection
or an inquiry command after the transition to programming/erasing state command, are examples.
Error Response
• Error response, H'80, (one byte): Command error
• Command, H'xx, (one byte): Received command
(8)
The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
The boot program will send ACK when the user MAT and user boot MAT have been erased
by the transferred erasing program.
An error occurred and erasure was not completed.
with a device-selection (H'10) command.
Transition to Programming/Erasing State
Command Error
Command Order
H'40
H'06
H'C0
H'80
H'51
H'xx
Section 20 Flash Memory (0.18-μm F-ZTAT Version)
Rev.6.00 Mar. 18, 2009 Page 797 of 980
REJ09B0050-0600