D12363VTE33 Renesas Electronics America, D12363VTE33 Datasheet - Page 643

• Manufacturer Part Number: D12363VTE33
• Description: MCU 3V 0K 120-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412363VTE33; HD6412363VTE33

and clear TDRE flag in SSR to 0
Write transmit data to TDR
Read TDRE flag in SSR
Read TEND flag in SSR
Clear TE bit in SCR to 0
Start of transmission
All data transmitted?
Clear DR to 0 and
Break output?
set DDR to 1
Initialization
TDRE = 1?
TEND = 1?
Figure 14.7 Sample Serial Transmission Flowchart
<End>
Yes
Yes
Yes
Yes
No
No
No
No
Section 14 Serial Communication Interface (SCI, IrDA)
[1]
[2]
[3]
[4]
[1] SCI initialization:
[2] SCI status check and transmit data
[3] Serial transmission continuation
[4] Break output at the end of serial
Note: * Not supported by the H8S/2366F.
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1, a frame
of 1s is output, and transmission is
enabled.
write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR and clear the
TDRE flag to 0.
procedure:
To continue serial transmission,
read 1 from the TDRE flag to
confirm that writing is possible,
then write data to TDR, and then
clear the TDRE flag to 0. Checking
and clearing of the TDRE flag is
automatic when the DMAC* or
DTC is activated by a transmit-
data-empty interrupt (TXI) request,
and data is written to TDR.
transmission:
To output a break in serial
transmission, set DDR for the port
corresponding to the TxD pin to 1,
clear DR to 0, then clear the TE bit
in SCR to 0.
Rev.6.00 Mar. 18, 2009 Page 583 of 980
REJ09B0050-0600