D12363VTE33 Renesas Electronics America, D12363VTE33 Datasheet - Page 894

• Manufacturer Part Number: D12363VTE33
• Description: MCU 3V 0K 120-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412363VTE33; HD6412363VTE33

Section 23 Power-Down Modes
23.2.4
Transition to Hardware Standby Mode: When the STBY pin is driven low, a transition is made
to hardware standby mode from any mode.
In hardware standby mode, all functions enter the reset state and stop operation, resulting in a
significant reduction in power dissipation. As long as the prescribed voltage is supplied, on-chip
RAM data is retained. I/O ports are set to the high-impedance state.
In order to retain on-chip RAM data, the RAME bit in SYSCR should be cleared to 0 before
driving the STBY pin low. Do not change the state of the mode pins (MD2 to MD0) while this
LSI is in hardware standby mode.
Clearing Hardware Standby Mode: Hardware standby mode is cleared by means of the STBY
pin and the RES pin. When the STBY pin is driven high while the RES pin is low, the reset state is
set and clock oscillation is started. Ensure that the RES pin is held low until the clock oscillator
stabilizes (for details on the oscillation stabilization time, refer to table 23.2). When the RES pin is
subsequently driven high, a transition is made to the program execution state via the reset
exception handling state.
Hardware Standby Mode Timing: Figure 23.3 shows an example of hardware standby mode
timing.
When the STBY pin is driven low after the RES pin has been driven low, a transition is made to
hardware standby mode. Hardware standby mode is cleared by driving the STBY pin high,
waiting for the oscillation stabilization time, then changing the RES pin from low to high.
Rev.6.00 Mar. 18, 2009 Page 834 of 980
REJ09B0050-0600
Oscillator
RES
STBY
Hardware Standby Mode
Figure 23.3 Hardware Standby Mode Timing
stabilization
Oscillation
time
exception
handling
Reset