E62655RUSB Renesas Electronics America, E62655RUSB Datasheet - Page 369

• Manufacturer Part Number: E62655RUSB
• Description: EMULATOR BASE H8S/2655R W/USB
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of E62655RUSB

• Contents: E6000 Emulator Unit and 4 Logic Probes
• For Use With/related Products: H8S/2655R
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

8.4
An interrupt request is issued to the CPU when the DTC finishes the specified number of data
transfers, or a data transfer for which the DISEL bit was set to 1. In the case of interrupt activation,
the interrupt set as the activation source is generated. These interrupts to the CPU are subject to
CPU mask level and interrupt controller priority level control.
In the case of activation by software, a software activated data transfer end interrupt (SWDTEND)
is generated.
When the DISEL bit is 1 and one data transfer has ended, or the specified number of transfers
have ended, after data transfer ends, the SWDTE bit is held at 1 and an SWDTEND interrupt is
generated. The interrupt handling routine should clear the SWDTE bit to 0.
When the DTC is activated by software, an SWDTEND interrupt is not generated during a data
transfer wait or during data transfer even if the SWDTE bit is set to 1.
8.5
Module Stop
When the MSTP14 bit in MSTPCR is set to 1, the DTC clock stops, and the DTC enters the
module stop state. However, 1 cannot be written in the MSTP14 bit while the DTC is operating.
On-Chip RAM
The MRA, MRB, SAR, DAR, CRA, and CRB registers are all located in on-chip RAM. When the
DTC is used, the RAME bit in SYSCR must not be cleared to 0.
DMAC Transfer End Interrupt
When DTC transfer is activated by a DMAC transfer end interrupt, regardless of the transfer
counter and DISEL bit, the DMAC’s DTE bit is not subject to DTC control, and the write data has
priority. Consequently, an interrupt request is not sent to the CPU when the DTC transfer counter
reaches 0.
Interrupts
Usage Notes
Rev. 5.00 Sep 14, 2006 page 339 of 1060
Section 8 Data Transfer Controller
REJ09B0331-0500