TMP91xy16FG Toshiba, TMP91xy16FG Datasheet - Page 137

• Manufacturer Part Number: TMP91xy16FG
• Manufacturer: Toshiba

Specifications of TMP91xy16FG

• Package: LQFP100
• Rom Types(m=mask,p=otp, F=flash,e=eeprom): Romless
• Rom Combinations: Romless
• Ram Combinations: Ramless
• Architecture: 16-bit CISC
• Usb/spi Channels: -
• Uart/sio Channels: 1
• I2c/sio Bus Channels: -
• (s)dram Controller: 1
• Adc 10-bit Channel: -
• Da Converter: -
• Timer 8-bit Channel: 4
• Timer 16-bit Channel: -
• Pwm 8-bit Channels: -
• Pwm 16-bit Channels: -
• Cs/wait Controller: 4
• Dual Clock: Y
• Number Of I/o Ports: 31
• Power Supply Voltage(v): 2.7 to 3.6

TXDCLK
SIOCLK
(6) The receiving buffers
(7) Transmission counter
(8) Transmission controller
structure.
register). When 7 or 8 bits of data have been stored in receiving buffer 1, the stored
data is transferred to receiving buffer 2 (SC1BUF); this causes an INTRX0 interrupt to
be generated. The CPU only reads receiving buffer 2 (SC1BUF). Even before the CPU
reads receiving buffer 2 (SC1BUF), the received data can be stored in receiving buffer 1.
However, unless receiving buffer 2 (SC1BUF) is read before all bits of the next data are
received by receiving buffer 1, an overrun error occurs. If an overrun error occurs, the
contents of receiving buffer 1 will be lost, although the contents of receiving buffer 2
and SC1CR<RB8> will be preserved.
the most significant bit (MSB) – in 9-bit UART mode.
setting SC1MOD0<WU> to 1; in this mode INTRX1 interrupts occur only when the
value of SC1CR<RB8> is 1.
which, like the receiving counter, counts the SIOCLK clock pulses; a TXDCLK pulse is
generated every 16 SIOCLK clock pulses.
•
•
15 16
To prevent overrun errors, the receiving buffers are arranged in a double-buffer
Received data is stored one bit at a time in receiving buffer 1 (which is a shift
SC1CR<RB8> is used to store either the parity bit – added in 8-bit UART mode – or
In 9-bit UART mode the wake-up function for the slave controller is enabled by
The transmission counter is a 4-bit binary counter which is used in UART mode and
In I/O interface mode
In UART mode
transmission buffer is output one bit at a time to the TXD0 pin on the rising edge
or falling edge of the shift clock which is output on the SCLK1 pin.
transmission buffer is output one bit at a time on the TXD1 pin on the rising or
falling edge of the SCLK1 input, according to the SC1CR<SCLKS> setting.
buffer, transmission starts on the rising edge of the next TXDCLK.
In SCLK output mode with the setting SC1CR<IOC> = 0, the data in the
In SCLK input mode with the setting SC1CR<IOC> = 1, the data in the
When transmission data sent from the CPU is written to the transmission
1
Figure 3.9.4 Generation of the Transmission Clock
2
3
4
5
91C016-135
6
7
8
9 10 11 12 13 14
15 16
1
TMP91C016
2008-02-20
2