HD64F2623FA20J Renesas Electronics America, HD64F2623FA20J Datasheet - Page 181

• Manufacturer Part Number: HD64F2623FA20J
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2623FA20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 7 Bus Controller
7.3.2
Bus Specifications
The external space bus specifications consist of three elements: bus width, number of access
states, and number of program wait states.
The bus width and number of access states for on-chip memory and internal I/O registers are
fixed, and are not affected by the bus controller.
(1) Bus Width: A bus width of 8 or 16 bits can be selected with ADWCR. An area for which an
8-bit bus is selected functions as an 8-bit access space, and an area for which a 16-bit bus is
selected functions as a16-bit access space.
If all areas are designated for 8-bit access, 8-bit bus mode is set; if any area is designated for 16-bit
access, 16-bit bus mode is set. When the burst ROM interface is designated, 16-bit bus mode is
always set.
(2) Number of Access States: Two or three access states can be selected with ASTCR. An area
for which 2-state access is selected functions as a 2-state access space, and an area for which 3-
state access is selected functions as a 3-state access space.
With the burst ROM interface, the number of access states may be determined without regard to
ASTCR.
When 2-state access space is designated, wait insertion is disabled.
(3) Number of Program Wait States: When 3-state access space is designated by ASTCR, the
number of program wait states to be inserted automatically is selected with WCRH and WCRL.
From 0 to 3 program wait states can be selected.
Table 7.3 shows the bus specifications for each basic bus interface area.
Rev. 5.00 Jan 10, 2006 page 155 of 1042
REJ09B0275-0500