HD64F2623FA20J Renesas Electronics America, HD64F2623FA20J Datasheet - Page 593

• Manufacturer Part Number: HD64F2623FA20J
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2623FA20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Mailbox (Message Control/Data (MCx[x], MDx[x]) Initial Settings: After power is supplied,
all registers and RAM (message control/data, control registers, status registers, etc.) are initialized.
Message control/data (MCx[x], MDx[x]) only are in RAM, and so their values are undefined.
Initial values must therefore be set in all the mailboxes (by writing 0s or 1s).
Setting the Message Transmission Method: Either of the following message transmission
methods can be selected with the message transmission method bit (MCR2) in the master control
register (MCR):
a. Transmission order determined by message identifier priority
b. Transmission order determined by mailbox number priority
When a is selected, if a number of messages are designated as waiting for transmission (TXPR =
1), the message with the highest priority set in the message identifier (MCx[5]–MCx[8]) is stored
in the transmit buffer. CAN bus arbitration is then carried out for the message in the transmit
buffer, and message transmission is performed when the transmission right is acquired. When the
TXPR bit is set, internal arbitration is performed again, and the highest-priority message is found
and stored in the transmit buffer.
When b is selected, if a number of messages are designated as waiting for transmission (TXPR =
1), messages are stored in the transmit buffer in low-to-high mailbox order (priority order:
mailbox 1 > mailbox 15). CAN bus arbitration is then carried out for the messages in the transmit
buffer, and message transmission is performed when the bus is acquired.
Setting a bit to 1 in the mailbox configuration register (MBCR) designates the corresponding
mailbox for reception use. When setting mailboxes for reception, to improve message
transmission efficiency, high-priority messages should be set in low-to-high mailbox order
(priority order: mailbox 1 (MCx[1]) > mailbox 15 (MCx[15]).
Receive-only mailbox (mailbox 0)
No setting is necessary, as this mailbox is always used for reception.
Section 15 Controller Area Network (HCAN)
Rev. 5.00 Jan 10, 2006 page 567 of 1042
REJ09B0275-0500