HD64F2623FA20J Renesas Electronics America, HD64F2623FA20J Datasheet - Page 753

• Manufacturer Part Number: HD64F2623FA20J
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2623FA20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

21B.3 Medium-Speed Mode
In high-speed mode, when the SCK2 to SCK0 bits in SCKCR are set to 1, the operating mode
changes to medium-speed mode as soon as the current bus cycle ends. In medium-speed mode, the
CPU operates on the operating clock ( /2, /4, /8, /16, or /32) specified by the SCK2 to SCK0
bits. The bus masters other than the CPU (DTC) also operate in medium-speed mode. On-chip
supporting modules other than the bus masters always operate on the high-speed clock ( ).
In medium-speed mode, a bus access is executed in the specified number of states with respect to
the bus master operating clock. For example, if /4 is selected as the operating clock, on-chip
memory is accessed in 4 states, and internal I/O registers in 8 states.
Medium-speed mode is cleared by clearing all of bits SCK2 to SCK0 to 0. A transition is made to
high-speed mode and medium-speed mode is cleared at the end of the current bus cycle.
If a SLEEP instruction is executed when the SSBY bit in SBYCR is cleared to 0, and LSON bit in
LPWRCR is cleared to 0, a transition is made to sleep mode. When sleep mode is cleared by an
interrupt, medium-speed mode is restored.
When the SLEEP instruction is executed with the SSBY bit = 1, LPWRCR LSON bit = 0, and
TCSR (WDT1) PSS bit = 0, operation shifts to the software standby mode. When software
standby mode is cleared by an external interrupt, medium-speed mode is restored.
When the RES pin is set low and medium-speed mode is cancelled, operation shifts to the reset
state. The same applies in the case of a reset caused by overflow of the watchdog timer.
When the STBY pin is driven low, a transition is made to hardware standby mode.
Figure 21B.2 shows the timing for transition to and clearance of medium-speed mode.
supporting module clock
Bus master clock
Internal address bus
Internal write signal
,
Figure 21B.2 Medium-Speed Mode Transition and Clearance Timing
SBYCR
Section 21B Power-Down Modes [H8S/2626 Group]
Medium-speed mode
Rev. 5.00 Jan 10, 2006 page 727 of 1042
SBYCR
REJ09B0275-0500