upd70f3402 Renesas Electronics Corporation., upd70f3402 Datasheet - Page 220

• Manufacturer Part Number: upd70f3402
• Description: 32-/16-bit Single-chip Microcontroller With Can Interface
• Manufacturer: Renesas Electronics Corporation.

5.5.2 External wait function
To synchronize an extremely slow external device, I/O, or asynchronous system, any number of wait
states can be inserted in the bus cycle by using the external wait pin (WAIT).
Access to each area of the internal ROM, internal RAM, and on-chip peripheral I/O is not subject to
control by the external wait function, in the same manner as the programmable wait function.
The WAIT signal can be input asynchronously to CLKOUT, and is sampled at the falling edge of the
clock in the T2 and TW states of the bus cycle in the multiplexed bus mode. In the separate bus mode,
it is sampled at the rising edge of the clock immediately after the T1 and TW states of the bus cycle. If
the setup/hold time of the sampling timing is not satisfied, a wait state is inserted in the next state, or
not inserted at all.
5.5.3 Relationship between programmable wait and external wait
Wait cycles are inserted as the result of an OR operation between the wait cycles specified by the set
value of the programmable wait and the wait cycles controlled by the WAIT pin. In other words, the
number of wait cycles is determined by the side with the greatest number of cycles.
For example, if the timing of the programmable wait and the WAIT pin signal is as illustrated below,
three wait states will be inserted in the bus cycle.
Remark:
220
Programmable wait
Wait via WAIT pin
The circles indicate the sampling timing.
Wait control
Figure 5-5: Example of Inserting Wait States in Separate Bus Mode
CLKOUT
WAIT pin
Programmable wait
Wait by WAIT pin
T1
Chapter 5 Bus Control Function
User’s Manual U16702EE3V2UD00
T2
TW
TW
Wait control
TW
T3