HD6412340 HITACHI [Hitachi Semiconductor], HD6412340 Datasheet - Page 414

• Manufacturer Part Number: HD6412340
• Description: H8S/2345 F-ZTAT Hardware Manual
• Manufacturer: HITACHI [Hitachi Semiconductor]

Bit 7—Overflow Flag (OVF): Indicates that TCNT has overflowed from H'FF to H'00, when in
interval timer mode. This flag cannot be set during watchdog timer operation.
Bit 7
OVF
0
1
Bit 6—Timer Mode Select (WT/IT): Selects whether the WDT is used as a watchdog timer or
interval timer. If used as an interval timer, the WDT generates an interval timer interrupt request
(WOVI) when TCNT overflows. If used as a watchdog timer, the WDT generates the WDTOVF
signal* when TCNT overflows.
Note: * The WDTOVF pin function is not supported by the F-ZTAT version.
Bit 6
WT/IT
0
1
Notes: 1. The WDTOVF pin function is not supported by the F-ZTAT version.
Bit 5—Timer Enable (TME): Selects whether TCNT runs or is halted.
Bit 5
TME
0
1
Bits 4 and 3—Reserved: Read-only bits, always read as 1.
2. For details of the case where TCNT overflows in watchdog timer mode, see section
11.2.3, Reset Control/Status Register (RSTCSR).
Description
[Clearing condition]
Cleared by reading TCSR when OVF = 1, then writing 0 to OVF
[Setting condition]
Set when TCNT overflows (changes from H'FF to H'00) in interval timer mode
Description
Interval timer: Sends the CPU an interval timer interrupt request (WOVI)
when TCNT overflows
Watchdog timer: Generates the WDTOVF signal *
Description
TCNT is initialized to H'00 and halted
TCNT counts
1
when TCNT overflows *
(Initial value)
(Initial value)
(Initial value)
2
399