MC9S12G FREESCALE [Freescale Semiconductor, Inc], MC9S12G Datasheet - Page 250

• Manufacturer Part Number: MC9S12G
• Description: Ignores external trigger. Performs one conversion sequence and stops.
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Interrupt Module (S12SINTV1)
6.4
The INT module processes all exception requests to be serviced by the CPU module. These exceptions
include interrupt vector requests and reset vector requests. Each of these exception types and their overall
priority level is discussed in the subsections below.
6.4.1
The CPU handles both reset requests and interrupt requests. A priority decoder is used to evaluate the
priority of pending interrupt requests.
6.4.2
The INT module contains a priority decoder to determine the priority for all interrupt requests pending for
the CPU. If more than one interrupt request is pending, the interrupt request with the higher vector address
wins the prioritization.
The following conditions must be met for an I bit maskable interrupt request to be processed.
Since an interrupt vector is only supplied at the time when the CPU requests it, it is possible that a higher
priority interrupt request could override the original interrupt request that caused the CPU to request the
vector. In this case, the CPU will receive the highest priority vector and the system will process this
interrupt request first, before the original interrupt request is processed.
250
IVB_ADDR[7:0]
1. The local interrupt enabled bit in the peripheral module must be set.
2. The I bit in the condition code register (CCR) of the CPU must be cleared.
3. There is no SWI, TRAP, or X bit maskable request pending.
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.
Field
7–0
Functional Description
S12S Exception Requests
Interrupt Prioritization
Interrupt Vector Base Address Bits — These bits represent the upper byte of all vector addresses. Out of
reset these bits are set to 0xFF (that means vectors are located at 0xFF80–0xFFFE) to ensure compatibility
to HCS12.
Note: A system reset will initialize the interrupt vector base register with “0xFF” before it is used to determine
Note: If the BDM is active (that means the CPU is in the process of executing BDM firmware code), the
All non I bit maskable interrupt requests always have higher priority than
the I bit maskable interrupt requests. If the X bit in the CCR is cleared, it is
possible to interrupt an I bit maskable interrupt by an X bit maskable
interrupt. It is possible to nest non maskable interrupt requests, for example
by nesting SWI or TRAP calls.
the reset vector address. Therefore, changing the IVBR has no effect on the location of the three reset
vectors (0xFFFA–0xFFFE).
contents of IVBR are ignored and the upper byte of the vector address is fixed as “0xFF”. This is done
to enable handling of all non-maskable interrupts in the BDM firmware.
MC9S12G Family Reference Manual,
Table 6-3. IVBR Field Descriptions
NOTE
Description
Rev.1.01
Freescale Semiconductor