SAM9G45 Atmel Corporation, SAM9G45 Datasheet - Page 71

• Manufacturer Part Number: SAM9G45
• Manufacturer: Atmel Corporation

Specifications of SAM9G45

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

12. Reset Controller (RSTC)
12.1
12.2
12.3
Figure 12-1. Reset Controller Block Diagram
6438G–ATARM–19-Apr-11
Description
Embedded Characteristics
Block Diagram
Backup Supply
Main Supply
WDRPROC
POR
POR
wd_fault
The Reset Controller (RSTC), based on power-on reset cells, handles all the resets of the sys-
tem without any external components. It reports which reset occurred last.
The Reset Controller also drives independently or simultaneously the external reset and the
peripheral and processor resets.
The Reset Controller is based on two Power-on-Reset cells, one on VDDBU and one on
VDDCORE.
The Reset Controller is capable to return to the software the source of the last reset, either a
general reset (VDDBU rising), a wake-up reset (VDDCORE rising), a software reset, a user
reset or a watchdog reset.
The Reset Controller controls the internal resets of the system and the NRST pin. The NRST pin
is bidirectional. It is handled by the on-chip reset controller and can be driven low to provide a
reset signal to the external components or asserted low externally to reset the microcontroller. It
will reset the Core and the peripherals except the Backup region. There is no constraint on the
length of the reset pulse and the reset controller can guarantee a minimum pulse length.
The NRST pin integrates a permanent pull-up resistor to VDDIOP0 of about 100 kOhms.
The configuration of the Reset Controller is saved as supplied on VDDBU.
NRST
nrst_out
Reset Controller
Counter
Startup
Manager
NRST
user_reset
exter_nreset
SLCK
Manager
Reset
State
rstc_irq
proc_nreset
periph_nreset
backup_neset
SAM9G45
71