PNX1500E NXP Semiconductors, PNX1500E Datasheet - Page 515

• Manufacturer Part Number: PNX1500E
• Manufacturer: NXP Semiconductors

Specifications of PNX1500E

• Lead Free Status / Rohs Status: Not Compliant

NXP Semiconductors
Volume 1 of 1
PNX15XX_PNX952X_SER_N_4
Product data sheet
Figure 4:
SCK
WS
SDx
Serial Frame (64 Bits) of a 18-Bit Precision I
0
2.6.1 Serial Frame Limitations
2.6.2 WS Characteristics
2.6.3 I
1
left channel data
2
3
Due to the implementation, there is a minimum serial frame length requirement that is
operating-mode dependent according to
Table 4: Minimum Serial Frame Length in Bits
The WS signal is used to define the start point of a serial frame. The start of a frame
can be marked by a transition on WS 1 clock before the start of the first bit of a new
frame. This WS transition can be programmed to be either a positive or a negative
edge transition.
In addition, the WS signal can be programmed to be a 50% duty cycle wave form or a
pulse that is 1 clock cycle wide. If the WS is configured to be 1 single clock wide
pulse, the pulse spans the 2 clock cycles preceding the first bit of the new frame. If
the WS is configured to be a 50% duty cycle waveform, the active edge of the WS
signal occurs 1 clock cycle before the first bit of the new frame. If the serial frame is of
an even bit count, then the second transition of the WS signal occurs in the clock
cycle before the halfway point of the serial frame. If the serial frame is of an odd bit
count, then the portion of the WS wave that is in the low state has the extra clock
cycle.
With an odd bit count for a serial frame and with a frame starting with a negative edge
of the WS, a 50% duty cycle WS signal would have the first part of the WS signal 1
clock longer than the second half. With a positive edge of the WS signal marking the
start of a serial frame, the second half of the serial frame would have a WS signal
longer by 1 clock cycle.
Figure 4
to transmit 16 or 32 bits of stereo data via an I
converter with a 64-bit serial frame.
Operating Mode
16 bit/sample, mono
32 bit/sample, mono
16 bit/sample, stereo
32 bit/sample, stereo
2
S Serial Framing Example
n (
and
17 18
18)
Table 5
Rev. 4.0 — 03 December 2007
30 31 32 33
show how the Audio Out module MMIO registers should be set
right channel data
2
S D/A Converter
Minimum Serial Frame Length
13 bits
13 bits
13 bits
36 bits
49 50 51
n
Table
(18)
2
4.
52
S serial standard to an 18-bit D/A
PNX15xx/952x Series
62 63
Chapter 15: Audio Output
0
left channel data
1
© NXP B.V. 2007. All rights reserved.
n+1
(18)
15-515