PNX1500E NXP Semiconductors, PNX1500E Datasheet - Page 632

• Manufacturer Part Number: PNX1500E
• Manufacturer: NXP Semiconductors

Specifications of PNX1500E

• Lead Free Status / Rohs Status: Not Compliant

NXP Semiconductors
Volume 1 of 1
Table 8: Registers Description
Table 9: Destination Address Base
PNX15XX_PNX952X_SER_N_4
Product data sheet
Bit
23:16
15:8
7:0
Bit
Offset 0x04 F404
31:29
28:24
23:16
15:8
7:0
Symbol
Off[22:16]
Off[15:8]
Off[7:0]
Symbol
Swap[2:0]
Reserved
Off[22:16]
Off[15:8]
Off[7:0]
Destination Address Base
This register specifies the offset for pixel (0,0) of a source bitmap for XY to Linear
conversion of addresses.
This register is interpreted as a byte address. The lower three bits of this register
always read 0, regardless of the value written. This implies that the source base
address must be aligned to a 64-bit boundary.
Under many circumstances, this register will be initialized to the proper offset and
then changed only for special effects.
This register specifies the offset for pixel (0,0) of a destination bitmap for XY to Linear
conversion of addresses.
This register is interpreted as a byte address. The lower three bits of this register are
always interpreted as 0, regardless of the value written. When reading the contents of
this register, the lower three bits will be read back as 0. This implies that the source
base address must be aligned to a 64-bit boundary.
Under many circumstances, this register will be initialized to the proper offset and
then changed only for special effects.
Acces
s
R/W
R/W
R/W
Acces
s
R/W
R/W
R/W
R/W
Value
-
-
-
Value
-
-
-
-
Rev. 4.0 — 03 December 2007
Description
Specifies the offset for pixel (0,0) of a source bitmap for XY to Linear
conversion of addresses. Bits 2:0 must be set to 0.
Description
Specifies endian-swapping on reads from memory.
When Swap[2] is 0, swapping is determined by the global endian
setting, possibly modified by BSI[0] in EngineConfig.
When Swap[2] is 1, swapping is determined by Swap[1:0] as shown:
00=No swapping. Memory is little-endian.
01=Bytes are swapped within each 16-bit word.
10=Words are swapped within each 32-bit double word.
11=Bytes are swapped within each 32-bit double word.
Specify the offset for pixel (0,0) of a destination bitmap for XY to
Linear conversion of addresses. Bits 2:0 must be set to 0.
PNX15xx/952x Series
Chapter 20: 2D Drawing Engine
© NXP B.V. 2007. All rights reserved.
20-632