R5S72011 RENESAS [Renesas Technology Corp], R5S72011 Datasheet - Page 117

• Manufacturer Part Number: R5S72011
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

4.6.2
Place the crystal resonator and capacitors CL1 and CL2 as close to the XTAL and EXTAL pins as
possible. In addition, to minimize induction and thus obtain oscillation at the correct frequency,
the capacitors to be attached to the resonator must be grounded to the same ground. Do not bring
wiring patterns close to these components.
4.6.3
Since various characteristics related to the resonator are closely linked to the user's board design,
thorough evaluation is necessary on the user's part, using the resonator connection examples
shown in this section as a guide. As the parameters for the oscillation circuit will depend on the
floating capacitance of the resonator and the user board, the parameters should be determined in
consultation with the resonator manufacturer. The design must ensure that a voltage exceeding the
maximum rating is not applied to the resonator pin.
Note on Using Crystal Resonator
Note on Resonator
Signal lines prohibited
EXTAL
CL1
Figure 4.3 Note on Using Crystal Resonator
This LSI
XTAL
CL2
Reference value
CL1 = 10 to 22 pF
CL2 = 10 to 22 pF
Note:
The values for CL1 and CL2
should be determined after
consultation with the crystal
resonator manufacturer.
Rev. 2.00 Sep. 07, 2007 Page 89 of 1164
Section 4 Clock Pulse Generator (CPG)
REJ09B0321-0200