R5F213J6CNNP#U0 Renesas Electronics America, R5F213J6CNNP#U0 Datasheet - Page 624

• Manufacturer Part Number: R5F213J6CNNP#U0
• Description: MCU 1KB FLASH 32K ROM 36-QFN
• Manufacturer: Renesas Electronics America
• Series: R8C/3x/3JCr

Specifications of R5F213J6CNNP#U0

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, PWM, Voltage Detect, WDT
• Number Of I /o: 31
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2.5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 36-WQFN Exposed Pad, 36-HWQFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/3JC Group
REJ09B0602-0100 Rev.1.00
May 12, 2010
28.7
Table 28.7
Function
Resolution
A/D conversion start condition • Software trigger
A/D conversion stop condition • If two pins are selected, when A/D conversion of the two selected pins
Interrupt request generation
timing
Analog input pin
Storage resister for A/D
conversion result
Reading of result of A/D
converter
In single sweep mode, the input voltage to two or four pins selected from among AN0 to AN1, AN3 to AN6, and
AN8 to AN11 are A/D converted once.
Table 28.7 lists the Single Sweep Mode Specifications. Figure 28.8 shows the Operating Example of Single Sweep
Mode.
Single Sweep Mode
Item
Single Sweep Mode Specifications
The input voltage to the pins selected by bits ADGSEL1 to ADGSEL0 and
the SCAN0 bit in the ADINSEL register is A/D converted once.
8 bits or 10 bits
• Timer RD
• Timer RC
• External trigger
• If four pins are selected, when A/D conversion of the four selected pins
• Set the ADST bit to 0.
• If two pins are selected, when A/D conversion of the two selected pins
• If four pins are selected, when A/D conversion of the four selected pins
AN0 to AN1 (2 pins), AN8 to AN9 (2 pins), AN8 to AN11 (4 pins)
(Selectable by the SCAN0 bit and bits ADGSEL1 to ADGSEL0.)
AD0 register: AN0, AN8
AD1 register: AN1, AN9
AD2 register: AN10
AD3 register: AN11
Read the registers from AD0 to AD3 corresponding to the selected pin.
(Refer to 28.3.3 A/D Conversion Start Condition)
completes (the ADST bit in the ADCON0 register is set to 0).
completes (the ADST bit is set to 0).
completes.
completes.
Specification
28. A/D Converter
Page 593 of 715