NH82801HBM S LB9A Intel, NH82801HBM S LB9A Datasheet - Page 414

• Manufacturer Part Number: NH82801HBM S LB9A
• Description: CONTROLLER HUB, ICH8M, I/O, 82801HBM
• Manufacturer: Intel

Specifications of NH82801HBM S LB9A

• Power Dissipation Pd: 2.4W
• Digital Ic Case Style: BGA
• No. Of Pins: 676
• Pci Bus Type: I/O Controller Hub
• Pci Express Base Spec: PCIe 1.1
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9.8.3.20
Note:
9.8.3.21
414
SS_CNT— Intel SpeedStep
Control Register (Mobile Only)
I/O Address:
Default Value
Lockable:
Power Well:
Writes to this register will initiate an Intel SpeedStep technology transition that
involves a temporary transition to a C3-like state in which the STPCLK# signal will go
active. An Intel SpeedStep technology transition always occur on writes to the
SS_CNT register, even if the value written to SS_STATE is the same as the previous
value (after this “transition” the system would still be in the same Intel SpeedStep
technology state). If the SS_EN bit is 0, then writes to this register will have no effect
and reads will return 0.
C3_RES— C3 Residency Register (Mobile Only)
I/O Address:
Default Value
Lockable:
Power Well:
Software may only write this register during system initialization to set the state of the
C3_RESIDENCY_MODE bit. It must not be written while the timer is in use.
31:24
23:0
7:1
Bit
Bit
0
Reserved
SS_STATE (Intel SpeedStep
read, it returns the last value written to this register. By convention, this will be the
current Intel SpeedStep technology state. Writes to this register causes a change to the
Intel SpeedStep technology state indicated by the value written to this bit. If the new
value for SS_STATE is the same as the previous value, then transition will still occur.
0 = High power state.
1 = Low power state
NOTE: This is only a convention because the transition is the same regardless of the
Reserved
C3_RESIDENCY — RO. The value in this field increments at the same rate as the Power
Management Timer. If the C3_RESEDENCY_MODE bit is clear, this field automatically
resets to 0 at the point when the Lvl3 or Lvl4 read occurs. If the C3_RESIDENCY_MODE
bit is set, the register does not reset when the Lvl3 or Lvl4 read occurs. In either mode,
it increments while STP_CPU# is active (i.e., the processor is in a C3 or C4 state). This
field will roll over in the same way as the PM Timer, however the most significant bit is
NOT sticky.
Software is responsible for reading this field before performing the Lvl3/4 transition.
Software must also check for rollover if the maximum time in C3/C4 could be
exceeded.
NOTE: Hardware reset is the only reset of this counter field.
value written to this bit.
PMBASE +50h
01h
No
Core
PMBASE +54h
00000000h
No
Core
®
®
Technology
technology State) — R/W (Special). When this bit is
Description
Description
Size:
Usage:
Attribute:
Size:
Usage:
Attribute:
LPC Interface Bridge Registers (D31:F0)
R/W (special)
8-bit
ACPI/Legacy
R/W/RO
32-bit
ACPI/Legacy
Intel
®
ICH8 Family Datasheet