MMCCMB2107 Freescale, MMCCMB2107 Datasheet - Page 341

• Manufacturer Part Number: MMCCMB2107
• Manufacturer: Freescale

Specifications of MMCCMB2107

• Lead Free Status / RoHS Status: Not Compliant

MMC2107 – Rev. 2.0
MOTOROLA
NOTE:
Serial Communications Interface Modules (SCI1 and SCI2)
TE — Transmitter Enable Bit
RE — Receiver Enable Bit
When LOOPS = 0 and TE = RE = 1, the RXD pin is an input and the
TXD pin is an output regardless of the state of the DDRSC1 (TXD) and
DDRSC0 (RXD) bits.
RWU — Receiver Wakeup Bit
SBK — Send Break Bit
This read/write bit enables the transmitter and configures the TXD pin
as the transmitter output. Toggling TE queues an idle frame. Reset
clears TE.
This read/write bit enables the receiver. Reset clears RE.
This read/write bit puts the receiver in a standby state that inhibits
receiver interrupt requests. The WAKE bit determines whether an idle
input or an address mark wakes up the receiver and clears RWU.
Reset clears RWU.
Setting this read/write bit causes the SCI to send break frames of 10
(M = 0) or 11 (M =1) logic 0s. To send one break frame, set SBK and
then clear it before the break frame is finished transmitting. As long as
SBK is set, the transmitter continues to send break frames.
Freescale Semiconductor, Inc.
For More Information On This Product,
1 = Transmitter enabled
0 = Transmitter disabled
1 = Receiver enabled
0 = Receiver disabled
1 = Receiver asleep when RE = 1
0 = Receiver awake when RE = 1
1 = Transmitter sends break frames.
0 = Transmitter does not send break frames.
Go to: www.freescale.com
Serial Communications Interface Modules (SCI1 and SCI2)
Memory Map and Registers
Technical Data
341