NH82801FBM S L89K Intel, NH82801FBM S L89K Datasheet - Page 383

• Manufacturer Part Number: NH82801FBM S L89K
• Manufacturer: Intel

Specifications of NH82801FBM S L89K

• Lead Free Status / RoHS Status: Compliant

10.5.7
Intel
®
I/O Controller Hub 6 (ICH6) Family Datasheet
REDIR_TBL—Redirection Table (LPC I/F—D31:F0)
Index Offset:
Default Value:
The Redirection Table has a dedicated entry for each interrupt input pin. The information in the
Redirection Table is used to translate the interrupt manifestation on the corresponding interrupt pin
into an APIC message.
The APIC will respond to an edge triggered interrupt as long as the interrupt is held until after the
acknowledge cycle has begun. Once the interrupt is detected, a delivery status bit internally to the
I/O APIC is set. The state machine will step ahead and wait for an acknowledgment from the APIC
unit that the interrupt message was sent. Only then will the I/O APIC be able to recognize a new
edge on that interrupt pin. That new edge will only result in a new invocation of the handler if its
acceptance by the destination APIC causes the Interrupt Request Register bit to go from 0 to 1.
(In other words, if the interrupt was not already pending at the destination.)
63:56
55:48
47:17
Bit
16
15
14
13
12
Destination — R/W. If bit 11 of this entry is 0 (Physical), then bits 59:56 specifies an APIC ID. In this
case, bits 63:59 should be programmed by software to 0.
If bit 11 of this entry is 1 (Logical), then bits 63:56 specify the logical destination address of a set of
processors.
Extended Destination ID (EDID) — RO. These bits are sent to a local APIC only when in Processor
System Bus mode. They become bits 11:4 of the address.
Reserved
Mask — R/W.
0 = Not masked: An edge or level on this interrupt pin results in the delivery of the interrupt to the
1 = Masked: Interrupts are not delivered nor held pending. Setting this bit after the interrupt is
Trigger Mode — R/W. This field indicates the type of signal on the interrupt pin that triggers an
interrupt.
0 = Edge triggered.
1 = Level triggered.
Remote IRR — R/W. This bit is used for level triggered interrupts; its meaning is undefined for edge
triggered interrupts.
0 = Reset when an EOI message is received from a local APIC.
1 = Set when Local APIC/s accept the level interrupt sent by the I/O APIC.
Interrupt Input Pin Polarity — R/W. This bit specifies the polarity of each interrupt signal
connected to the interrupt pins.
0 = Active high.
1 = Active low.
Delivery Status — RO. This field contains the current status of the delivery of this interrupt. Writes
to this bit have no effect.
0 = Idle. No activity for this interrupt.
1 = Pending. Interrupt has been injected, but delivery is not complete.
destination.
accepted by a local APIC has no effect on that interrupt. This behavior is identical to the device
withdrawing the interrupt before it is posted to the processor. It is software's responsibility to
deal with the case where the mask bit is set after the interrupt message has been accepted by
a local APIC unit but before the interrupt is dispensed to the processor.
10h
3E
Bit 16
All other bits undefined
–
–
3Fh (vector 23)
11h (vector 0) through
=
1,.
Description
LPC Interface Bridge Registers (D31:F0)
Attribute:
Size:
R/W, RO
64 bits each, (accessed as
two 32 bit quantities)
383