TMPM361F10FG Toshiba, TMPM361F10FG Datasheet - Page 188

• Manufacturer Part Number: TMPM361F10FG
• Manufacturer: Toshiba

Specifications of TMPM361F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Contact Us
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14Ã?14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 3
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

8.2
Port functions
8.2.8
Type
8.2.8.1
8.2.8.2
in units of bits. Besides the general-purpose input / output function, the port L performs the serial interface func-
tion(UART/SIO), the serial bus interface function(I2C/SIO), External signal interrupt input and 16bit timer out-
put function.
to the corresponding bit of the three registers. If you use the port L as other than a general-purpose port, set
"1" to the corresponding bit of the function register. Do not set "1" to the some function registers at the same
time.
put in the PLIE register. These settings enable the interrupt input even if the CGSTBYCR<DRVE> bit in the
clock / mode control block is set to stop driving of pins during STOP mode.
Port L data register
Port L output control register
Port L function register 1
Port L function register 2
Port L function register 3
Port L open drain control register
Port L pull-up control register
Port L input control register
Port L (PL0 to PL7)
The port L is a general-purpose, 8-bit input / output port. For this port, inputs and outputs can be specified
Reset initializes all bits of the port L as general-purpose ports with input, output and pull-up disabled.
The Port L has three types of of function register. If you use the port L as a general-purpose port, set "0"
To use the external interrupt input for releasing STOP mode, select this function in the PLFR1 and enable in-
Note:: In modes other than STOP mode, interrupt input is enabled regardless of the PLFR1 register set-
Port L Circut Type
Port L register
ting if input is enabled in PxIE. Make sure to disable unused interrupts when programming the device.
T21
7
T24
6
Register name
T23
5
Page 164
T22
4
PLDATA
PLPUP
PLFR1
PLFR2
PLFR3
PLCR
PLOD
PLIE
T21
3
T20
Base Address = 0x400C_0B00
2
Address (Base+)
0x000C
0x002C
0x0000
0x0004
0x0008
0x0010
0x0028
0x0038
T20
1
TMPM361F10FG
T20
0