TMPM361F10FG Toshiba, TMPM361F10FG Datasheet - Page 654

• Manufacturer Part Number: TMPM361F10FG
• Manufacturer: Toshiba

Specifications of TMPM361F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Contact Us
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14Ã?14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 3
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

22.3
On-board Programming of Flash Memory (Rewrite/Erase)
(6)
erase protection bits. If it is desired to stop the operation, use the hardware reset function. When the
automatic operation to erase protection bits is normally terminated, it returns to the read mode.
contained in the device. The data to be loaded will be different depending on the address [15:14] of
the fourth and subsequent bus write cycles (recommended input data is 0x00). After the fourth bus
write cycle, when an arbitrary flash memory area is read, the ID value will be loaded. Once the
fourth bus write cycle of an ID-Read command has passed, the device will not automatically return
to the read mode. In this condition, the set of the fourth bus write cycle and ID-Read commands
can be repeatedly executed. For returning to the read mode, use the Read/reset command or hard-
ware reset command.
In any case, any new command sequence is not accepted while it is in an automatic operation to
Using the ID-Read command, you can obtain the type and other information on the flash memory
Note:The FCFLCS <RDY / BSY> bit is "0" while in automatic operation and it turns to "1"
ID-Read
when the automatic operation is terminated.
Page 630
TMPM361F10FG