TMPM361F10FG Toshiba, TMPM361F10FG Datasheet - Page 200

• Manufacturer Part Number: TMPM361F10FG
• Manufacturer: Toshiba

Specifications of TMPM361F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Contact Us
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14Ã?14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 3
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

8.2
Port functions
8.2.10
Type
8.2.10.1
8.2.10.2
in units of bits. Besides the general-purpose input / output function, the port N performs the serial interface func-
tion (UART/SIO), External signal interrupt input,16bit timer output function and the remote control signal pre-
processor input function.
to the corresponding bit of the three registers. If you use the port N as other than a general-purpose port, set
"1" to the corresponding bit of the function register. Do not set "1" to the some function registers at the same
time.
input in the PNIE register. These settings enable the interrupt input even if the CGSTBYCR<DRVE> bit in
the clock / mode control block is set to stop driving of pins during STOP mode.
Port N data register
Port N output control register
Port N function register 1
Port N function register 2
Port N function register 3
Port N open drain control registert
Port N pull-up control register
Port N input control register
The port N is a general-purpose, 4-bit input / output port. For this port, inputs and outputs can be specified
Reset initializes all bits of the port N as general-purpose ports with input, output and pull-up disabled.
The Port N has three types of of function register. If you use the port N as a general-purpose port, set "0"
To use the external interrupt input for releasing STOP mode, select this function in the PNFR1 and enable
Port N (PN0 to PN3)
Note:In modes other than STOP mode, interrupt input is enabled regardless of the PNFR1 register setting
Port N Circuit Type
Port N register
if input is enabled in PxIE. Make sure to disable unused interrupts when programming the device.
7
−
6
−
Register name
−
5
Page 176
4
−
PNDATA
PNPUP
PNFR1
PNFR2
PNFR3
PNCR
PNOD
PNIE
T30
3
T25
Base Address = 0x400C_0D00
2
Address (Base+)
0x000C
0x002C
0x0000
0x0004
0x0008
0x0010
0x0028
0x0038
T29
1
TMPM361F10FG
T28
0